BEA ULTIMO IXIO Universal Rain Accessory Instructions
- June 10, 2024
- BEA
Table of Contents
UNIVERSAL RAIN ACCESSORY
Bracket accessory for ULTIMO and IXIO sensors
Visit website for available languages of this document.
ULTIMO IXIO Universal Rain Accessory
BEA, INC. INSTALLATION/SERVICE COMPLIANCE EXPECTATIONS
BEA, Inc., the sensor manufacturer, cannot be held responsible for incorrect
installations or incorrect adjustments of the sensor/device; therefore, BEA,
Inc. does not guarantee any use of the sensor/ device outside of its intended
purpose.
BEA, Inc. strongly recommends that installation and service technicians be
AAADM-certifi ed for pedestrian doors, IDA-certifi ed for doors/gates, and
factory-trained for the type of door/gate system.
Installers and service personnel are responsible for executing a risk
assessment following each installation/service performed, ensuring that the
sensor/device system performance is compliant with local, national, and
international regulations, codes, and standards.
Once installation or service work is complete, a safety inspection of the
door/gate shall be performed per the door/gate manufacturer’s recommendations
and/or per AAADM/ANSI/DASMA guidelines (where applicable) for best industry
practices. Safety inspections must be performed during each service call –
examples of these safety inspections can be found on an AAADM safety
information label (e.g. ANSI/DASMA 102, ANSI/DASMA 107, UL294, UL325, and
International Building Code).
Verify that all appropriate industry signage, warning labels, and placards are
in place.
MOUNTING & ASSEMBLY
-
Verify the existing mounting location orientation:
• ULTIMO: the bottom of the sensor is no more than 5” from the bottom of the door header
• IXIO: the bottom of the sensor is no more than 2” from the bottom of the door header
-
Place the Universal Rain Accessory (URA) base in the desired mounting location, and mark and drill pilot holes. Remove existing sensor if necessary.
-
Secure the URA base to the mounting location using the provided screws.
-
Secure the sensor to the URA base using the screws provided with the sensor.
-
Wire as instructed in the applicable sensor’s User’s Guide and secure the sensor cover.
-
Slightly pull the sides of the cover and insert the pin guides on the inside of the URA cover into the outside of the URA base.
Tech Support & Customer Service:
1-800-523-2462 | General Tech
Questions: techservices-us@BEAsensors.com | Tech Docs:
www.BEAsensors.com
©BEA | Original Instructions
75.0056.02 UNIVERSAL RAIN ACCESSORY 20221215
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>