BENY BCPP-A1-16 Portable EV Charger User Manual
- October 30, 2023
- BENY
Table of Contents
BCPP-A1-16 Portable EV Charger
User Manual
Portal At EV Charger User Manual
Safety Information
Think you for. pun:hasmg and us\mg the Bony\ electric vehicle mode 2 charger.
This document contains important instructions and warnings that must be
followed when using and maintaining the EV Charger.
In order o help you use the product correct, please read this manual irefully
before charging.
Warning
- Read this entire mandatory document before using the EV charger.
- This device should be supervised when used around children.
- Do not install or use the EV Charger near flammable, explosive, harsh, or ‘combustible materials, chemicals, or vapors.
- Use the EV Charger only within the specified operating parameters.
- Stop using and do not use the EV Charger if it is defected, cracked, frayed, broken, or otherwise damaged, or fails to operate.
- Do not attempt to disassemble, repair, tamper with, or modify the EV Charger. Contact us for any repairs or maintenance.
- Do not touch the EV Charger’s end terminals with sharp metallic objects, such as wire, tools, or needs.
- Do not forcefully fold or apply pressure to any part of the EV Charger or damage it with sharp objects.
- Do not insert foreign objects into any part of the EV Charger.
- Before use, please confirm whether the parameters of the electric vehicle match the charger’s, otherwise it may cause damage to the vehicle.
Warning
- For safe electricity usage, it is not recommended to use the device to charge in the open air on rainy days
- Do not immerse the AC charging device in water
- Do not step on the cable, pull the cable, bend the cable or tie the cable
- Do not drop the control box or put heavy objects on its surface
- Do not place the device near objects that generate high temperature while charging
- Do not put the device in the car or in a closed space while charging
- Do not operate the EV Charger in temperatures outside its operating range of -30°C to +50°C.
Notes
- For electric vehicle charging only
- This product must be well grounded when using
- Do ot use the device when the charging cable is damaged
- Do not put your fingers in the charging plug
- Do not use extra wires or adapters
- This product does not contain user maintainable parts, please do not attempt to repair and maintain it yourself
- If the device cannot be charged normally according to this operation manual, please contact the dealer for repair or replacement
Product Introduction
The charger is designed according to IEC 62752, IEC 61851-21-2 standard,
mainly consists of control box, charging connector, plug and etc… Which is a
portable electric vehicle charging device.
It enables car owners to charge electric vehicles anywhere using a standard
home power interface, featuring high efficiency and portability.
2.1. Product Appearance
2. 2. Product Specifications
Item Model | Parameter BCPP-A1-16 |
---|---|
Standard | IEC 62752,IEC 61851-21-2 |
Rated Input/output Voltage | 230V AC |
Frequency | 50Hz/60Hz |
Rate Charging Current | 8A/10A/13A/16A |
Standby Power Consumption | <1.5W |
Operating Temperature | -30°C-50°C |
Operating Humidity | 5%-95% |
IP Protection | IP66 |
Safety Protection | Leakage Protection, Over Current Protection, Over Voltage |
Protection, Fire Protection, Under Voltage Protection, Over Temperature
Protection, Neutral and Live Wire Reverse Connection Protection, Relay
Adhesion Protection, Ground Protection, Lightning Protection, CP Signal
Abnormal Protector Anti-pressure Protection
Insulation Resistance| >100M0
Dielectrically Strength| 1430VACtImin
Impulse Withstand Voltage| 2.5KV
Working Life| <10000 times
Flame Retardant Rating| UL94-VO
Operating Altitude| <2000m
Charger Dimension| L:200mm W:90mm H:55.5mm
Plug Cable Length| 1 m
.. Total Length| 7m as standard (Customized length available)
2.3. Plug Types
C a | EU(German) | AU | ZA |
---|---|---|---|
Model Type | PE-307 | YP-39A | YP-80 |
CurrentNoltage | 16A/250V- | 20A/250V- | 16A/250V- |
Wire | HO7BZ5-F | ||
3G 2.5mm- | HO5VV-F | ||
3G 2.5mm2 | Y Y 3G 2.5mm2 | ||
Material | V.0 | P.V.0 | P.V.0 |
UK | BRA | ||
--- | --- | --- | |
Model Type | YP-61A | YP-05 | |
CurrentNoltage | 13A/250V- | 16A/250V- | |
Wire | HO5VV-F 3G 2.5mm2 | HO5W-F 3G 2.5mm2 | |
Material | P.V.0 | P.V.0 |
2. 4. Product Packing List
NO | Item | Quantity |
---|---|---|
1 | Portable EV Charger | 1 |
2 | Portable EV Charger Bag | 1 |
3 | User Manual | 1 |
2. 5. Protection Functions
With full protection to avoid all kinds of charging safety hazards, it will automatic power off after the vehicle is fully charged, to protect the car battery and prolong the working life.
2. 6. Product Features
Built-in with Over Current Protection, Over Voltage Protection, Under Voltage
Protection, Over Temperature Protection, Neutral and Live Wire Reverse
Connection Protection, Relay Adhesion Protection, Ground Protection, CP
Signal Abnormal Protection, Fire Protection,Anti-pressure Protection and Type
B
Leakage Protection.
- It can be charged by appointment, 0-24 hours.
- Adjustable Charging Current for Easy Charging.
- Automatically recharge after power failure recovery.
- With lightning protection device to ensure personal safety.
- With OLED screen display, more intuitive and clear.
- With Touch key-press, more flexible and convenient operation.
- P66 protection, operating humidity range 5%-95% for indoor and outdoor.
- Operating temperature range: -30 °C ~ +50 °C.
- Standard: IEC 62752, IEC 61851-21-2.
Operating Status
3.1. LED Light Description
| | Normal Status| |
---|---|---|---|---
LED Lights Status| LED Lights Status| EV Charger Status| Potential Cause|
Action
| LED Off| No Power| Power is not on| Check Power
| Green light on| Standby| |
| Streaming light runs back and forth| Plug the connector to set timer
charging (Not ready to charge)| |
| Streaming light runs two ends to middle| The charger is ready, the vehicle
is not ready.| |
| LED light runs
from middle to end (Not to bottom)| Charging without current| Unplugged to
start charging| Check if connector plugged
| Streaming light runs from middle to up and down| Charging normally| |
| All lights on green| Charging completed| |
| | Fault Status| |
---|---|---|---|---
LED Lights Status| OLED Screen Status| EV Charger Status| Potential Cause|
Action
| | Emergency Stop Protection| Accidentally touch the emergency stop| Pull out
the charging connector and re-plug it
| | CP Signal Abnormal Protection| Charging connector loose| Tighten charging
connector
| | Protection Over Current| Short Circuit| Waiting for professional repair
| | Over Temperature Protection| The ambient temperature is too high to cause
an alarm| Wait for the temperature recover and automatically recharge
| | Poor grounding| Ground wire not connected| Check if socked is grounded,
if without grounding wire you can turn or emergency charging
| | Neutral and live wire reverse connection| Neutral and live wire reverse
connection| Correct the Neutral and liv( wire connector
LED Lights status| OLED Screen Status| Fault Status
EV Charger Status| Potential Cause| Action
---|---|---|---|---
| | Over Voltage Protection| Short circuit of home lines or unstable of grid
power| Check the home lines… Wait for grid power to recover
| | Under Voltage Protection| Insufficient grid voltage| Wait for grid power
to recover
| | Leakage Protection| There is residual current| Check if there is a leakage
of end of the vehicle
| | Relay Abnormal| Relay
Adhesion| Emergency stop charging, restart charger to check if it is normal;
If not, please contact the dealer
| | Relay Abnormal| Relay
No Action
3.2. OLED Screen Description
Picture| Status
Poor grounding| Press Left Key| Press Right Key| Press Left an.
Right Toga the
Ignore poor grounding and start charging
---|---|---|---|---
| Wait for Plug| | | Enter interface of setting
| Setting| Set max charging current| Set timer charging| Save Settings
| Charging| | | Enter interface for emergency stop charging
| Emergency stop charging| Stop| Cancel|
| Neutral and live wire reverse connection| | | Manual reset (Correct the
wiring)
How to Plug and Play
How to set charging current
How to set a timed charging
How to emergency stop charging
How to set temporarily charging when the socket without ground wire
Warranty Description
Free warranty is available for any damages o failures due to the chargers’
quality problems since 1 year from the date of producing at the factory.
Any damages caused by failure of operations, irresistible natural reasons,
wrong installation or use against with the instructions, is not covered by the
warranty. Non-professionals are not allowed to repair the chargers. Any
problems during installation or use, please contact the dealer first.
<https://www.beny.com/>
ZHEJIANG BENYI ELECTRICAL CO., LTD.
Acres : Wenzhou Dacia Industry Park, Hueing City Zhuang Province 325603 China.
TEL: +86.577.6717 7008 Emil: bonyi@zpeny.com
VERSION : 20220416
BENY.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>