DESIGN HOUSE 589150-BLK Desta 3 LT Vanity Light Instruction Manual
- October 30, 2023
- DESIGN HOUSE
Table of Contents
DESIGN HOUSE 589150-BLK Desta 3 LT Vanity Light
DESTA 3 LT Vanity Light
SKU#589150-BLK / 589150-SN
Product Information
- This vanity light can be installed in an uplight or downlight position.
- The product comes in two colors: black (SKU#589150-BLK) and satin nickel (SKU#589150-SN).
- The product requires a Phillips screwdriver for installation.
- All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards. If you are unfamiliarwith proper electrical wiring connections obtain the services of a qualified electrician.
Usage Instructions
Before installation, turn off the main power at the circuit breaker to prevent possible shock.
- Remove the fixture and mounting package from the box and ensure that all parts are present by referring to the illustrations on theinstallation instructions.
- Using a Phillips screwdriver, assemble and install the fixture according to the instructions provided.
- After installation, turn on the power at fuse or circuit breaker.
- If you are unsure about the electrical installation, consult a licensed electrician.
For any inquiries or concerns, please contact customer serviceat 1-800-558-8700.
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture,
in order to prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and National
Electrical Code (N.E.C.) standards.
If you are unfamiliar with proper electrical wiring connections obtain the
services of a qualified electrician. Remove the fixture and the mounting
package from the box and make sure that no parts are missing by referencing
the illustrations on the installation instructions. Tools are required when
installing this fixture.
REQUIRED TOOLS
Phillips screwdriver
ASSEMBLY AND INSTALLATION
This light can be installed in an uplight or a downlight position.
Turn off the power at fuse or circuit breaker
-
Carefully unpack the fixture, lay out all parts on a clean surface.
-
Fasten the MOUNTING RING onto the OUTLET BOX by using 2 OUTLET BOX SCREWS provided.
-
Tie ground wire from OUTLET BOX and from fixture to the GROUND SCREW on the MOUNTING RING.
Connect white wire from fixture to white wire (neutral wire) from supply circuit. Connect black wire from fixture to black wire (live wire) from supply circuit. Cover connections using provided WIRE CONNECTORS. -
Place the WALL PLATE over the MOUNTING SCREWS, then secure them with LOCK NUTS until tightened.
-
Place the GLASS SHADES over the sockets and secure with the SOCKET RINGS tightly.
-
Install the BULBS (not included).
Turn on the power at fuse or circuit breaker
ITEM# 589150-BLK / 589150-SN
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION, CONSULT A LICENSED ELECTRICIAN.
- Customer Service: 1-800-558-8700
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>