DESIGN HOUSE 589564 Oak Creek Outdoor Wall Light Dusk to Dawn Downlight Instruction Manual
- May 15, 2024
- DESIGN HOUSE
Table of Contents
LED BLACKOUTDOOR WALL LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
Item# 589564: OAK CREEK DOWNLGT WALL LIGHT DUSK TO DAWN
Please read carefully and save these instructions, as you may need them at a
later date..
589564 Oak Creek Outdoor Wall Light Dusk to Dawn Downlight
CAUTION
WARNING:Risk of Fire.Min90℃ supply conductors.Consult a qualified
electrician to ensure correct branch circuit conductor.
Turn off the main power at the circuit breaker before installing the fixture,
in order to prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and National
Electrical Code (N.E.C.) standards. If you are unfamiliar with proper
electrical wiring connections obtain the services of a qualified electrician.
Remove the fixture and the mounting package from the box and make sure that no
parts are missing by referencing the illustrations on the installation
instructions.
ASSEMBLY AND INSTALLATION
Turn off the power at fuse or circuit breaker.
- Gently take all parts out of the package and lay them on a smooth surface. Remove screws from top of back plate and remove mounting plate.
- Attach the mounting plate to the Junction box using two junction box screw .
- Connect the fixture wires to supply wires as shown in Fig.1,making sure that all wire connectors are secured. If your outlet box has a green or bare copper groundwire,connect the fixture groundwire to it. Otherwise, connect the fixture’s groundwire directly to the back plate using the green screw provided. After wires are connected,tuck them carefully inside the junction box.
- Place the fixture plate over the mounting plate and secure with two cap nuts and lock washers.
- Install the finials and waterproof washer on the fixture top.
- Install the bulbs onto the socket.
- To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the outside of the fixture back plate where it meets the wall. Leave a space at the bottom to allowmoisture to escape.
Turn on the power at fuse or circuit breaker
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
Customer Service 1-800-558-8700