NINJA Single Rider Golf Electric Scooter Instruction Manual
- October 30, 2023
- Ninja
Table of Contents
NINJA Single Rider Golf Electric Scooter
Product Information
The product is a scooter with a front windshield, rear support, roof, roof bracket, front support, and a golf rack. The product comes with M860 bolts to install the front roof bracket, M650 bolts to install the roof, M870 bolts to install the rear support, M845 bolts to install the Golf rack, M640-hex bolts to install front support, and M640-round head bolts to install the glass. The product also has a seat, charger, and battery compartment. The product comes with a faucet tube and handle, which can be installed using screws. The product comes with a push rod under the seat to fix the seat and a Golf Stand.
Product Usage Instructions
- Install the front roof bracket using M8*60 bolts.
- Install the roof using M6*50 bolts.
- Install the rear support using M8*70 bolts.
- Install the Golf rack using M8*45 bolts.
- Install the front support using M6*40-hex bolts.
- Install the glass using M6*40-round head bolts.
- Install the seat by pulling the push rod under the seat and fixing it in place.
- Insert the battery into the battery compartment and connect the battery cable.
- Install the faucet tube and handle by grasping the handle and moving out of the scooter slowly, then installing the screw of the faucet handle.
- Install the Golf Stand by installing two parts as shown in the figure.
- Pay attention to the front and rear of the roof, then install two parts as shown in the figure and tighten the screws.
- Switch to electric mode and turn on the power.
- Drive the scooter.
WHAT IN BOX
PARTS
INSTALLATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>