SHAPE PRODUCTS SPE5536-72 Steel Window Well Installation Guide
- October 30, 2023
- SHAPE PRODUCTS
Table of Contents
SHAPE PRODUCTS SPE5536-72 Steel Window Well
Product Information
Steel Window Well
The Steel Window Well is a metal product designed to provide a sturdy and durable support system for basement windows. It is available in three different widths: 42, 50, and 67 inches, and comes with mounting hardware for easy installation. The well is designed to keep debris and pests out of your window and prevent falls, making it a safe and reliable choice for any homeowner.
PREPARATION
- Review local building codes to ensure compliance.
- Contact Diggers Hotline prior to excavating.
- NOTE: Homes with Ufer grounding and any improper electrical system grounding voids any claims for corrosion. All metal products must be isolated from stray electrical current.
- Ensure faucets, downspouts, sprinklers, and hoses are at least 10’ from the well and are aimed away from the well.
- Excavate a hole that is 12” wider than the well in all directions and 10” below the bottom edge of the window.
INSTALLATION
- Mark the location of the top mounting holes on the foundation.
- For 42” width model, holes should be 44” apart center to center.
- For 50” width model, holes should be 52” apart center to center.
- For 67” width model, holes should be 69” apart center to center.
- Drill two holes on the markings and remove all concrete dust from the holes before proceeding.
- Place your hardware in the hole and place well on the anchor. Add 1” flat washer and nut and tighten into place.
- Using the remaining flange holes, drill foundation wall at 12” centers mininum to assure structural stability.
- Place remaining hardware into the holes, add 1” flat washers and nuts and tighten into place. Connect window well drain into the foundation drainage system.
- Using hand tools only, backfill around the well in 12” of washed stone. Failure to fill well based on 12” of rock decreases the integrity of the well and will void manufacturers warranty.
- An egress ladder is required by code for wells 48” and higher. To prevent pests, debris, and falls into the window well a covers should be used. Ladder and cover sold separately.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>