SHAPE PRODUCTS 400030002522 Custom Window Well Cover Instruction Manual
- October 30, 2023
- SHAPE PRODUCTS
Table of Contents
CUSTOM WINDOW WELL COVER
DUAL LOCK INSTALLATION INSTRUCTIONS
Instruction Manual
INCLUDES
(6) Dual-Lock Discs
(6) Dual-Lock Self-Adhesive Pads
(6) 3/4” Screws
INSTALLATION
-
You will be installing (6) Dual-Lock Disc and Pads to your well and cover.
a. (2) will be installed 8” from the foundation wall, centered on the rim of the well.
b. (2) will be installed 30” from the fountation wall, centered on the rim of the well.
c. (2) will be installed 10” from the center point of the well.
-
Using a marker or pencil and a tape measure, measure and mark all (6) hardware locations. NOTE: Be sure to make markings as close to the center of the rim as possible.
-
ttach (6) Dual-Lock Discs at marked locations using the screws provided.
-
nce the Dual-Lock Discs are attached, place your window well over the well, ensuring it is centered. Use your pencil or marker to mark the center of the Dual-Lock Discs.
-
sing these marks, remove backing from each Dual-Lock Self-Adhesive Pad and adhere them to the underside of the cover.
NOTE: Each pad should be placed so it can attach to the corre-sponding disc.
-
et the adhesive cure for at least 1 hour. Once cured, align each Dual-Lock Self-Adhesive Pad with the corresponding Dual-Lock Disc and firmly press down until you feel the structures interlock.
CLEANING INSTRUCTIONS
Clean your window well cover with a mild solution detergent and water. Use of harsh chemicals or solvents may damage plastic and void warranty.
5205 Freitag Drive Menomonie, WI 54751
715-232-0495
shapeproducts.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>