Shantou Flying Technology FLY2021E 5-Inch LED Drone Stunt Glow Instruction Manual

**BLAUPUNKT AHE601 Humidifier Evaporative Instruction Manual

**

Introduction

Congratulations on your purchase of the LED Stunt Drone. Ifs time for some fun. This drone is capable of total controlled flight, fly up/down. left/right, and pitch forward or backward, on 6 axis gyro stabilization with a control range of 150 feet. Includes USB charging cable, replacement blades and for auto orientation, auto take-off and auto landing control. Included, is a 500 mAh Li-pod drone battery. The remote controller requires requires 3 AAA 1.5V batteries (not included). Alkaline batteries are recommended.

Please read all instructions and warnings in this manual prior to using your LED Stunt Drone, and keep this instruction manual as it contains important information for future reference. Adult assembly and a Phillips screwdriver will be required for battery installation.

Prepare for flight

• Drone must be charged before each use (Cable included).
• Indicator light on USB plug will turn off when fully charged.
• Install batteries in remote.

Pair your drone

Before each flight pair the remote with the drone:

1. Turn your drone on and place on a flat, level surface.
2. Turn on the remote.
3. Push the left stick up and then down.
4.  Repeat steps 1 and 2 if necessary.

Calibrate

• Move both joysticks diagonally in toward the middle of the remote.

Remote Control Overview

Practice flying your drone below 10 feet and at low speeds until comfortable with all controls to avoid unnecessary damage or injury.

• Left joystick: Up/Down controls elevation.
• Right joystick: controls flight direction.
• Direction Trim: Use to eliminate drift . To cut power to drone, move left joystick to down position.

General Warnings

SAFETY WARNINGS

• Not recommended for children under 14 years of age. As with all electrical products. precautions should be observed during handling and use to reduce the risk of electrical shock.
• Adult supervision is required at all times.
• Never fly drones above or near people, sudden changes in wind or other conditions could lead to unexpected crashes.
• Always use caution when flying drone vehicles, obey relevant laws, respect the privacy and property rights of others.
• The drone shall never be modified or used for anything except its intended purpose.
• Before each Jose. an adult should review the product and battery to determine that no damage or hazards exist.
• DO NOT TOUCH SPINNING PROPELLERS.
• Do not allow anything to intentionally make contact in any way with spinning propellers or prevent contact with spinning blades by turning off remote prior to handling drone.
• Use caution and pay attention to your surroundings while operating drone.
• Do not fly drone into animals, people, or inanimate objects.
• Keep drone away from power lines, buildings. trees. public areas, and any other potentially hazardous areas.
• Do not operate in rain, heavy wind, and or any type of severe weather.
• Do not land drone on wet surfaces.
• Never touch or allow others to touch drone while it is flying.
• Always turn drone off when it is not in use.
• Always fly drone in large open areas.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not :Cause harmful into reference, and (2) this device must accept any interference received, including interference that may cause undefined operation.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates. uses and can radiate radio frequency energy and. II not installed and used in accord- arise with the instructions. may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Fly-away are the responsibility of the individual pilot and will not be replaced by the manufacturer.

Contents

• LED Drone

• Drone Controller

• 4 Replacements Propellers.

• USB Charger Cable

Remote Battery Installation

1. Slide open the remotes battery compartment
2. Install 3 ‘AAA” batteries as shown in the diagram above.
3.  Replace and close battery compartment.

A\ BATTERY WARNING – LITHIUM-POLYMER:

There is I risk cd fire and  inert, e Lt-Po battery darner a muted

• Nor noose battery to extreme mange.
• Do not subject battery to strum mewls
• Ahem net battery array from flammable merely
• Ore tarn manteltree welded letting/. Charger WI or elope,11 speeded manufacturer.
• Ban try is not serviceable.
• Let battery coal m morn temperate Mkt*
• Mete Naïve. never Ware balmy unattended
• Recycle et Depose of battery according to Were. ME and ‘zee Into acne
  KEEP THIS FYCKAGING FOR REFDIDCE AS IT CONTAINS IMPORTANT Reid NATILIN.

Charging Battery

1. Turn off the drone before charging.
2. Connect the battery charger cable to the charging port on the drone.
3. Connect USB connector to the power source.
   

Note: The Battery Charger will light up when it is charging the battery and turn off when the battery is fully charged.

Replacing propellers

• Only an adult should replace blades. To remove, pull up the blades directly.
• Replace propellers by following the diagram.
• Each blade spins differently. Blade B spins counter clockwise and Blade A spins clockwise.
  

Remote Overview

Operation Drone

Step 1 – Pre-Flight Checklist.

1. Read all warnings and instructions.
2. Install remote batteries.
3. Charge batteries,
4. Make sure that the drone and remote are powered off.

Step 2 – Choosing a location.

• Drone is designed to be flown indoors and outdoors.
• Always make sure you have enough space to fly drone.
• Always follow warnings.

Step 3 – Pre-Right

• Make sure your remote is off.
• Push the power button on top of the drone and hold on 1-2s until LED lights on.
• Race drone on a flat even surface. For ease of control the blue lights should be toward you.
• Turn on the Remote controller. Push the left. stick up and then down.
• The drone’s lights will flicker during the pairing process and then remain on once it has paired.

Step.4 Lift Off

Press the Auto Take off Button.

Slowly and carefully press the Throttle stick. Drone will begin to elevate.

Step 5- Operating Drone In Flight

1. Follow this step It your drone begins to drift during lake off Or darning Flight.

2.  Use the Throttle Joystick to increase or decrease your  elevation

3.  Use the Multi Directional  Joystick to move forwards backwards or side to side.

4.  Stunts – Press the Stunt Button then press the Multi  Directional Joystick In the direction you want to complete a stunt.

A. Drone drifts backwards: Press the Forward Trim Button.
B. Drone drifts forwards: Press the Backwards Trim Button.
C. Drone drift right Press the Left Trim Button.
D. Drone drift left Press the Flight Trim Button.

Note:

1. The stunt function may be disabled if the drone battery power is low.
2. Hover the drone at or above 10 feet before attempt rig a stunt.

Step 6 – Landing Drone

1. Lower drone to 20 feet or less then press the Auto Land button. Use the Multi Directional Joystick to maneuver drone. Or Push the left iOS back down until the drone landing.
2. In the event the Modes will not stop spinning. you cm perform an emergency stop.

Step 7 – Retrieving Drone

1. Turn off your remote by pressing the Power Baton. This will stop you from accidentally turning the propeller son
2. Make sure the propellers have stopped spinning then pick up your drone.

Note: You will need to pair your drone again before your next flight. (part 1 of step 4).

Other Features

Auto Orientation

Press the Auto Orientation Button to turn the mode ON and then again to turn off.

• In this mode, the drone will always move in the direction you press the Multi Directional Button no matter which way the drone faces.
• To stop blades in case of an emergency.

When drone is in auto orientation mode, the drone will orient to the user (remote), no matter what direction the drone is facing.

• Press the Orientation button. Remote will beep every 6 seconds to indicate it is in Auto Orientation mode.
• Push the right stick up will send the drone away from the user, push left will move left. etc.
• Press Auto Orientation button to exit mode.
  

Tips:

• Do not crash drone into sand or dirt. Drone gears may become dogged.
• When first learning to fly, practice lifting off and hovering.
• Stay several feet from walls and buildings.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>