netvue Vigil 3 Outdoor FHD Night Camera User Guide

Your property guardian at day and night
Model: NI-1921

Vigil 3 Outdoor FHD Night Camera

Vigil 3 Quick Guide

Warning
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is  encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
  Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
  FCC ID 2AO8RNI-1921

CE RED
This product can be used across EU member states.

What’s In The Box

Drilling Template

Power Adapter

Mounting Screws

Anchors

Quick Guide

Vigil 3 Camera

Camera Structure

Insert Micro SD Card

The Vigil 3 has a built-in card slot that supports Micro SD cards up to 128GB. After inserting the memory card, the camera will automatically start recording video and store it on the memory card. You can view these videos in the Replay page by clicking the Replay button in the Home page.
Step 1: Open the bottom silicone plug.
Step 2: Insert the Micro SD card. Make sure to plug it in the right direction.
Step 3: Finally, close the silicone plug.

Read Before Installing

1. Keep the Vigil 3 Camera and all accessories out of reach of children and pets.

2. Power supply voltage that is required to operate Vigil Camera should be DC12V (≥1000mA).

3. The product can only be used in proper temperature and humidity:
   Operating temperature: -10°C – 50°C (14°F-122°F)
   Operating humidity: 0-95%.

4. Please do not expose the camera lens to direct sunlight.

5. Please do not install the camera to the place that is likely struck by lightning.

Note:

1. Netvue Vigil 3 Camera only works with 2.4GHz Wi-Fi.

2. Strong lights may interfere with the ability to scan the
   QR code.

3. Avoid placing the device behind furniture or near microwaves. Try to keep it within range of your Wi-Fi signal.

Set Up with Netvue App

https://download.netvue.com/

Download the Netvue App from App Store or Google Play. Follow the in-app instruction to complete the entire set up process.

Vigil 3 Camera Installation

Check following things before you starting to drill holes on your wall:

1. Vigil 3 Camera has been successfully added to your Netvue App and is able to stream video.
2. Have planned the cable route. Measured the length of the power cable.

Step 1:
Find a good installation spot.

• We recommend installing the Vigil 3 Camera just 7-10 feet (2-3 meters) above the ground for a better two-way audio experience.
• There is a power outlet nearby.
• Make sure Vigil 3 Camera can stream video smoothly at the spot.
• Make sure the camera’s sight is not blocked.
  

Step 2:
Before you starting to drill, make sure you know the locations of wall-in pipes and electrical wires. (If you are not comfortable with drilling holes, please consult with a licensed electrician.)

1. Use the provided drilling template to mark the position of holes on your wall. Use drill bit (15/64″, 6mm) to drill three holes.
2. Install anchors to hold screws. (Skip this step if installing on a wooden board.)

Step 3: Tighten the included screws to secure the camera.

Step 4:
Loosen the nuts on the base by hand. Aim the camera in the direction you specified and tighten the screws that link the machine to the base. Finally hand tighten the nuts on the base.

Netvue Protect Plan

Netvue Protect Plan provides optional advanced features for those with higher security needs, and each plan supports multiple devices.

my.netvue.com

Continuous Video Recording
Visit my.netvue.com to learn more.

FCC Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there  is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is  encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technicia

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Feel free to contact us for additional help:https://my.netvue.com/?utm_source=product_manual

| support@netvue.com
---|---
|  Netvue Forum
| In-App Chat
| @NetvueTech
****| 1(866)749-0567

netvue.com
240 W Whitter Blvd Ste A, La Habra, CA 90631
© Netvue Inc.

References

• my.netvue.com
• Bird Feeder Camera | Baby Monitor and Home Security Camera – netvue

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>