A O Smith CLARYUM Clean Water Filter Replacement User Manual

October 30, 2023
A O Smith

A O Smith CLARYUM logo CLARYUM Clean Water Filter Replacement

A O Smith CLARYUM Clean Water Filter Replacement User Manual

INSTALLATION STEPS AO-FF

  1. Turn off the water supply to your refrigerator or freezer filter. Release pressure from the system by activating the water dispenser in your refrigerator. Once there is no water coming from the water dispenser, you can change the filter.

  2. Remove the plastic from the filter replacement.
    Remove the filter housing from the system manifold by rotating it to the left and pulling down. Ensure the filter housings are not on an angle while removing. This may result in damage to the o-ring.A O Smith CLARYUM Clean
Water Filter Replacement - filter housings

  3. Hold the filter housing over the sink. Separate the two pieces by turning the bottom portion to the left. Pour excess water down the drain. Pull down on the filter housing to disconnect it from the top half. While the housing is open, inspect the o-ring for damage. If damaged, replace immediately. If misaligned, gently move the o-ring into place.

  4. Insert and connect the new filter replacement to the top half of the sump. Reattach the bottom of the filter housing to the top half by turning to the right and tightening.

  5. Reattach the filter housing to the bottom of the top housing by making sure all connection points are aligned. Push the top of the filter housing up into the bottom of the system manifold and turn to the right. Ensure that the filter housing is fully attached  and locked in.A O Smith CLARYUM Clean Water Filter Replacement - connection points NOTE: Do not use tools to tighten. Hand tighten only.

  6. Once the filter replacement has been changed and the filter housing is securely attached to the system manifold, slowly turn on the water supply to your refrigerator or freezer filter.
    Inspect the system for leaks.

  7. Allow filtered water to run through for one minute or until water is free from discoloration before drinking.
    NOTE: Do not drink flushed water.

NOTE: If filter housing is too tight to disconnect by hand, please use the plastic wrench included with original system.

A O Smith CLARYUM Clean Water Filter Replacement - disconnect by
hand

INSTALLATION STEPS AO-CWM

  1. Remove dispenser from filtration dock. With filtration dock facing forward, open top cover by rotating it a quarter-turn to the right until the top cover lifts off the filtration dock.
  2. Remove used filter from top cover by pulling down on the filter.
  3. Drop the filter replacement into the opening on the dock with the o-ring facing up.A O Smith CLARYUM Clean Water Filter Replacement - facing up
  4. After dropping the filter  replacement into the dock opening, push the reset button located on the top of the dock with a sharp pointed object. This will reset the filter status light on the system.
  5. Place the top cover on the dock. Press firmly and rotate the top cover a quarter-turn to the left until fully locked in. Ensure both tabs on the top cover are aligned with the dock.A O Smith CLARYUM Clean Water Filter Replacement - both tabs
  6. Once the filter has been replaced and the top cover is fully locked into filtration dock, fill dispenser with cold water and place back onto dock.
  7. Hold dispenser button down until all water has filtered through the system.
    NOTE: Do not drink flushed water.A O Smith CLARYUM Clean Water Filter
Replacement - dispenser button

|
---|---
Love it?
We welcome your rating & review.
Visit AOSmithatLowes.com/reviews| Need help?
Well be happy to assist you in any way at 877.333.7108
Please do not return to the store.

Tested and Certified by NSF International against NSF/ANSI Standards 42, 53, and 401 for the reduction of the claims specified on the Performance Data Sheet and at www.NSF.org.

https://qr1.be/9JEA

For the full list of contaminants filtered, scan to view the AO-FF Performance Data Sheet on AOSmith.com.
The recommended replacement frequency for the AO-FF is every 200 gallons of use or every 6 months.
Use only certified, genuine A. O. Smith replacement filters for continued contaminant removal and system performance.
Tested and Certified by NSF International against NSF/ANSI Standards 42, 53, and 401 for the reduction of the claims specified on the Performance Data Sheet and at www.NSF.org.

https://qr1.be/9EVB

The recommended replacement frequency for the AO-CWM is every 320 gallons of use or every 6 months.
Use only certified, genuine A. O. Smith replacement filters for continued contaminant removal and system performance.

A. O. Smith Corporation P.O. Box 1597
Johnson City, TN 37605-1597 | 877.333.7108
AO-US-100-R_install_Aug2022

Documents / Resources

| A O Smith CLARYUM Clean Water Filter Replacement [pdf] User Manual
CLARYUM Clean Water Filter Replacement, CLARYUM, Clean Water Filter Replacement, Water Filter Replacement, Filter Replacement, Replacement
---|---

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals