THE HOME DEPOT CA2316-2H 2-Light Antique Zinc Pot Rack Kitchen Island Chandelier Instruction Manual
- October 30, 2023
- THE HOME DEPOT
Table of Contents
ASSEMBLY AND INSTALLATION INSTRUCTIONS
CA2316-2H
WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER
WHILE INSTALLING OR SERVICING THIS FIXTURE
NOTES:
-
Before installing, consult local electrical codes for wiring and grounding requirements.
-
READ AND SAVE THESE INSTRUCTIONS.
IMPORTANT:FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION.
-
Attach the mounting plate to the outlet box by using two mounting screws.
-
se two rubber saplings to align the mounting plate holes and drive them into the ceiling, and then use two wood screws to fix the mounting plate.
-
Two sets of elbow assemblies (A) are inserted into the rectangular decorative bottom ring (B) and fixed and tightened with four screws. The corresponding holes of the two sets of elbow assemblies are then inserted with a headless screw (C) , fixed and tightened with a decorative nut (D) .
-
It is then locked with an open latch and a chain attached to the upper and lower rings.
CONNECTION THE WIRES (Fig. 2) -
Connect the electrical wires as shown in Fig. 2.making sure that all wire connectors (B) are secured .lf your outlet box has a ground wire (green or bare copper).connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the cross bar using the green screw provided.
-
Put the rectangular sucker into the mounting plate, align the holes on both sides, then fix and tighten it with four screws.
-
Insert the two shadows into the socket, then fasten them with the socket ring.
-
E26 Bulb (Bulb not included). Turn on the power at fuse or circuit box.