CSCLED CLW08C LED Corn Lamp Instructions
- June 5, 2024
- CSCLED
Table of Contents
CSCLED CLW08C LED Corn Lamp
Instruction
Instruction
Installation
It could be easily installed using a straight screwdriver. Use a flat-blade
screwdriver to unscrew the plug and remove the plug. And then. Choose a motion
sensor to install and tighten.
Note: the motion sensor has no dialing code, and remote control is needed
for adjustment. Please refer to the instruction for remote control adjustment.
Function
Adopted dual PD technology, HB01DMS-A/B is able to differentiate artificial light brightness from natural light after being installed inside the fixture, and automatically turn off light when ambient brightness exceeds preset lux level Light automatically on when the ambient brightness is lower than preset lux level. With insufficient ambient brightness, the light dims to 100% when motion is detected. The light dims to stand-by level if no motion is detected after hold time. Light off when ambient lux level is higher than preset lux amount.
Warning
DISCONNECT POWER AT THE SERVICE ENTRANCE BEFORE CLEANING OR
SERVICING. ADD GRILLE CURRENT TO FAN CURRENT FOR TOTAL CURRENT DRAW. INSTALL
ONLY WITH MODELS INDICATED IN THE INSTALLATION INSTRUCTIONS.
COUPEZ L’ALIMENTATION AU PANNEAU ÉLECTRIQUE AVANT LES TRAVAUX DE NETTOYAGE OU
D’ENTRETIEN. ADDITIONNEZ LA CONSOMMATION DE COURANT DE LA GRILLE À CELLE DU
VENTILATEUR POUR OBTENIR L’APPEL TOTAL DE COURANT. S’INSTALLE UNIQUEMENT AVEC
LES MODÈLES INDIQUÉS DANS LES DIRECTIVES D’INSTALLATION.
FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. if this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>