SEALEY SCR9.V3 Mechanics Utility Seat Instructions
- June 4, 2024
- SEALEY
Table of Contents
SEALEY SCR9.V3 Mechanics Utility Seat
IMPORTANT
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
SAFETY
WARNING
- Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this seat.
- Locate seat in a suitable working area.
- Use seat on level and solid ground, preferably concrete.
- Keep the seat clean and tidy in accordance with good workshop practice.
- DO NOT use the seat for any purpose other than that for which it is designed.
- DO NOT stand on the seat.
- DO NOT use the seat outdoors.
- DO NOT get the seat wet or use in damp or wet locations or areas where there is condensation.
- DO NOT clean the seat with any solvents which may damage the paint surface or the protective coating on the padded seat base.
- DO NOT exceed maximum capacity of 110kg.
INTRODUCTION
Steel framework with powder coated finish. Extra thick cushioned padding for added comfort when seated. Easy-rolling Ø63mm rubber castors with ball bearing swivel. Composite storage tray for tools and components.
SPECIFICATION
- Model No: SCR9.V3
- Max. Capacity:110kg
- Overall Size (W x D x H):355 x 360 x 385mm
ASSEMBLY
Start by placing the tray on the base frame. Slot theMcastors through the frame from the underside and secure to the tray with the cap nuts, washers and splitNwashers. Attach the two seat support frames to the base frame with the four bolts, cap nuts and washers. Place the seat cushion upside down, place the two support bars on the underside of the cushion. Turn the framework upside down and place on top of the cushion and support bars, secure using the four screws and washers. Turn the seat upright, the product is now ready to use.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids
according to local regulations.
Note
It is our policy to continually improve products and as such we reserve the
right to alter data, specifications and component parts without prior notice.
Important
No Liability is accepted for incorrect use of this product.
Warranty
Guarantee is 12 months from purchase date, proof of which is required for any
claim.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>