Uixe SSL-12151M-PC 1-Light Matte Black Outdoor Wall Lantern Sconce Sensor Instruction Manual
- October 30, 2023
- UIXE
Table of Contents
ASSEMBLY INSTRUCTIONS
SSL-12151M-PC 1-Light Matte Black Outdoor Wall Lantern Sconce Sensor
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
HARDWARE INCLUDED
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS
INSTALLATION
STEP 1
Unscrew the ball nuts from the mounting unit.
Use the mounting screws to attach the mounting unit to the junction box(not
included).
STEP 2
Make the electrical connection from the junction box to the fixture.
Connect the ground wire to the mounting unit using the preinstalled green
ground screw. Then, connect the positive, negative and ground wires with the
supplied wire nuts. Secure with electrical tape.
STEP 3
Attach the fixture to the mounting unit through screw holes as shown, and
secure it with screws.
NOTICE: Please use caulk in the back plate and wall mounting surface to
prevent water from entering.
STEP 4
Install bulbs (not included).
OPERATING INSTRUCTIONS
- Light control switch is an automatic controller, can be used for outdoor and indoor light control automatic lighting, when the night comes illuminance ≦10Lux, the lamp will be automatically lit, and in the day when the illumination ≧30Lux, the lamp will automatically turn off the lamp.
- Rated voltage: 120VAC/60Hz; The bulb should be installed at less than the rated power of the sensor; Energy-saving lamp/ballast /LED 39W; Incandescent lamp 100W.
- The photosensor should be installed in a place with good photosensitivity, without obstacles affecting its acceptance of natural light, and backlit with the lamp source, so as to prevent the product from jumping when sensing its own light.
- There should be no swinging objects in front of the photosensor.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>