CURT 51446 Trailer Brake Controller Harness Instruction Manual
- June 4, 2024
- Curt
Table of Contents
The FIRST Name in Towing Products™
**INSTALLATION INSTRUCTIONS
Scan for helpful installation tips
http://qr.curtmfg.com/video/51447
**
51446 & 51447 APPLICATIONS
| Make | Model |
|---|---|
| Dodge | Durango (w/ factory tow package) |
| Jeep | Grand Cherokee (w/ factory tow package) |
BRAKE CONTROL HARNESS
NOTICE
All steps must be followed to ensure the CURT brake control harness will
function properly. Once installed test for proper function by following the
brake control unit instruction manual.
LOCATION GUIDE
Representative vehicle is shown below BH8 – Under the dash, to the right of the emergency brake pedal
INSTALLATION / SAFETY INSTRUCTIONS
Step 1
Locate the felt liner under the dash, to the left of the steering column.
Remove the two plastic fasteners securing the liner (A). Behind the felt
liner, locate the vehicle brake control harness connector. It will be attached
to the top of a junction box (B). The connector will be similar to that on the
CURT brake control harness.
Step 2
Insert the connector on the CURT brake control harness into the vehicle
connector. Make sure the connector is fully inserted with locking tabs in
place.
Step 3
Insert the brake control harness’s black connector into the brake control’s
quick plug connector. Secure the brake control harness with the provided cable
ties, avoiding any inch points.
Step 4
Complete the installation using the brake control instructions. Mount the unit
as directed and perform test procedures as instructed in the brake controller
user manual.
CURTMFG.COM • NEED ASSISTANCE? • 1.877.287.8634 • RA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>