INVENTUM HZ31 Foot Muff Instruction Manual

: June 4, 2024
: INVENTUM

Table of Contents

INVENTUM HZ31 Foot Muff
- explanation of symbols
- Important safety instructions – read carefully and keep for later
Appliance description
Intended use
Operation
cleaning & maintenance
Disposal.
Problems & solutions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

INVENTUM HZ31 Foot Muff

explanation of symbols

| Read the instructions!|
| Do not wash.|

---|---|---|---|---

| Do not bleach.|
| Do not insert pins!|
| Do not dry in dryer.|
| Do not iron.|
| Do not use when the foot warmer is folded or rolled!|
| Do not dry clean.|
| The textiles used for this device meet stringent human ecological requirements

of Oeko -Tex Standard 100, as verified by Hohenstein Research Institute.

|

| Do not use

for very young children

(0-3 years of age).

|

| Dispose of the packaging in an environmentally friendly way.|
| Manufacturer|
| This product satisfies

the requirements of the applicable European

and national directives.

|

| A quality mark for electrical appliances that meet the safety requirements of DEKRA SE

(formerly KEMA).

|

| The device has double protective insulation

and therefore complies

with protection class 2.

| | Please dispose of the device in accordance with EC Directive – WEEE

(Waste Electrical and Electronic Equipment).

---|---|---|---

| WARNING; Warning of risk of injury or danger to your health.
| CAUTION; Safety information about possible damage to the device/accessories.
| NOTE; Refers to important information.

Important safety instructions – read carefully and keep for later

reference!

WARNING

Non-observance of the following notes may result in personal injury or material damage (electric shock, skin burns, ﬁre). The following safety and hazard information is not only intended to protect your health and the health of others, it should also protect the product. For this reason, pay attention to these safety notes and include these instructions when handing over the product to others.
This foot warmer must not be used by persons who are not sensitive to heat or by other vulnerable persons who may not be able to react to overheating (e.g. diabetics, people with skin alterations due to illness or scarred tissue in the application area, after taking pain relief medication or alcohol).
This foot warmer must not be used by very young children (0-3 years old) as they are unable to respond to overheating.
This foot warmer can be used by children older than 3 and younger than 8 years of age provided they are supervised. For this, the control must always be set to the minimum temperature.
This foot warmer may be used by children over the age of 8 and by people with reduced physical, sensory or mental skills or a lack of experience or knowledge, provided that they are supervised and have been instructed on how to use the foot warmer safely, and are fully aware of the consequent risks of use.
Children must not play with the foot warmer.
Cleaning and user maintenance must not be performed by children unless supervised.
This foot warmer is not designed for use in hospitals.
This foot warmer is only intended for domestic/private use, not for commercial use.
This foot warmer must not be used to keep animals warm.
Do not use this foot warmer with shoes.
Do not insert pins.
Do not use when folded or bunched up.
Do not use if wet.
This foot warmer must only be connected to the mains voltage that is speciﬁed on the label.
The electrical and magnetic ﬁelds emitted by this foot warmer may interfere with the function of a pacemaker. However, they are still well below the limits: electrical ﬁeld strength: max. 5000 V/m, magnetic ﬁeld strength: max. 80 A/m, magnetic ﬂux density: max. 0.1 millitesla. Please therefore consult your doctor and the manufacturer of your pacemaker before using this foot warmer.
Do not pull, twist or make sharp bends in the cables.
If the cable and control are not positioned properly, there may be
a risk of becoming entangled in, being strangled by, tripping over, or stepping on the cable and control of the foot warmer. The user must ensure that excess lengths of cable, and cables in general, are safely routed.
Please check this foot warmer frequently for signs of wear and tear or damage. If any such signs are evident, if the foot warmer has been used incorrectly or if it no longer heats up, it must be checked by the manufacturer before being switched on again.
Under no circumstances should you open or repair the foot warmer (including the accessories) yourself because faultless functionality can no longer be guaranteed thereafter. Failure to observe this will invalidate the warranty.
If the mains connection cable of this foot warmer is damaged, it must be disposed of. If it cannot be removed, the foot warmer must be disposed of.
When this foot warmer is switched on:
- Do not place any sharp objects on it
- Do not place any heat sources, such as hot water bottles, heat pads or similar, on it
The electronic components in the control warm up when the foot warmer is in use. For this reason, the control must never be covered or placed on the foot warmer when it is in use.
It is essential to observe the information relating to the following chapters: Operation, Cleaning and maintenance, Storage.
If you should have any questions about using our devices, please contact our Customer Services department.

Appliance description

HZ30/HZ31
Electric foot warmer
Size: 26 x 26 x 32 cm
Switch with 3 illuminated settings Automatic switch off after 90 minutes Removable lining hand washable 100 Watt

Illuminated display for temperature settings
Mains plug
Sliding switch for ON/OFF and temperature settings
Mains cable
Control
Foot warmer

Intended use

CAUTION
This foot warmer is intende only for heating human feet.

Operation

Safety

CAUTION

The foot warmer has been provided with the INVENTUM SAFETY SYSTEM (ISS). This sensor technology prevents overheating of the foot warmer on the entire surface through automatic deactivation in case of breakdown. If the SAFETY SYSTEM has switched off the foot warmer, the temperature levels in activated condition are no longer lighted.
Do note that for reasons of safety the foot warmer can no longer be used after a breakdown and should be sent to the indicated service address.

Initial use

CAUTION
Make sure the foot warmer does not fold or crumple during use.

Insert the plug in the socket.

Switching on

To switch on the foot warmer, set the slider for ON/OFF and temperature settings to setting 1, 2 or 3. The temperature setting is illuminated when switched on.

Setting the temperature

Setting 0: OFF
Setting 1: minimum heat
Setting 2: medium heat
Setting 3: maximum heat

NOTE

The fastest way to heat up the foot warmer is to select the highest temperature setting of the control, ﬁrst.

NOTE

This foot warmer has a fast heating function, which allows the foot warmer to warm up faster in the ﬁrst
10 minutes.

WARNING
If the foot warmer is used continuously (for several hours) it is reccomended to use the lowest setting (1) of the control to avoid overheating of the feet of the user, which may lead to burns to the skin.

Automatic switch off

This foot warmer is equipped with an automatic switch-off function. This turns off the heat supply approx. 90
minutes after the initial use of the foot warmer. The temperature setting display then starts to ﬂash. So that the foot
warmer can be switched back on, the sliding switch for ON/OFF and temperature setting must ﬁrst be set to setting 0
(OFF). After about 5 seconds it is possible to switch it on again.

Switching off

To switch off the foot warmer, set the slider for ON/OFF and temperature settings to setting 0 (OFF). The temperature settings are then no longer illuminated.

NOTE
If the foot warmer is not in use, switch the sliding switch for ON/OFF and temperature settings to setting 0 (OFF) and unplug the mains plug from the socket.

cleaning & maintenance

WARNING
Before cleaning, always remove the mains plug from the socket ﬁrst. Otherwise there is a risk of electric shock.
CAUTION
The control must never get in contact to water or other liquids. Otherwise, the control may be damaged.

To clean the control, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
Small marks on the foot warmer can be removed with a damp cloth or sponge, or if necessary, with a little liquid detergent for delicate laundry.

CAUTION
Please note that the foot warmer may not be washed, chemically cleaned, wrung out, tumble dried, put through a mangle or ironed. Failure to do so may damage the foot warmer.

The removable ﬂeece lining can be washed by hand.
Use a delicate laundry detergent and measure it out according to the manufacturer’s instructions.

CAUTION

Please allow the footwarmer to cool down ﬁrst. Otherwise, the footwarmer may be damaged.
To avoid sharp folds in the footwarmer, do not place objects on top of it while it is being stored.

Disposal.

Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling. Electrical and electronic equipment marked with the symbol indicating separate collection of such equipment must be returned to a municipal waste collection point.

Problems & solutions

Problem Cause Remedy
The temperature settings are not illuminated while

the mains plug is connected to a working socket;
the sliding switch is set to 1, 2 or 3.
The safety system has switched the foot warmer off permanently.
Send the foot warmer to the service
department.