INVENTUM KP602B Hot Plate Instruction Manual
- June 3, 2024
- INVENTUM
Table of Contents
INVENTUM KP602B Hot Plate Instruction Manual
safety instructions
-
Carefully and fully read the instruction manual prior to using the appliance and carefully store the manual for future reference.
-
Only use this appliance for the purposes described in the instruction manual.
-
Caution! Avoid contact with hot parts when the appliance is switched on.
-
Only connect the appliance to alternate current, to an earthed wall socket, with a mains voltage that corresponds with the information provided on the information plate of the appliance.
-
Never bend the power cord sharply or allow it to run across hot parts.
-
Fully unwind the cord to prevent it from overheating.
-
Never place the appliance near appliances that give off heat, such as ovens, gas cookers, hotplates, etc. Keep the appliance away from walls or other objects that could catch flame, such as curtains, towels (cotton or paper, etc.).
-
Always make sure the appliance is placed on an even, flat and heat-resistant surface and is only used indoors.
-
Do not leave the appliance unsupervised if the appliance is operational.
-
If you want to move the appliance, make sure the appliance is switched off and fully cooled down.
-
Do not use the appliance if the plug, cord or appliance are damaged, or if the appliance no longer functions properly or if it is damaged in any other way. If this is the case, consult the shop or our technical service. Never replace the plug or cord yourself. Repairs to electrical appliances should only be performed by skilled persons.
Incorrect repairs could cause considerable hazards for the user.
Never use the appliance with parts that are not recommended or supplied by the manufacturer. -
Do not pull the cord and/or appliance to remove the plug from the wall socket. Never touch the appliance with wet or moist hands.
-
Never connect the appliance to an external timer or a separate remote control system, in order to prevent hazardous situations.
-
Keep the appliance out of reach of children. Children do not see the dangers when handling electrical appliances. Therefore, never allow children to work with electrical appliances without supervision.
Keep the appliance and cord out of reach of children younger than 8 years of age. -
The appliance can be used by children of 8 years and older and persons with a limited physical, sensory or mental capacity or lack of experience or knowledge, provided they use the appliance under supervision or have been instructed about its safe use and understand the hazards involved.
-
Children are not allowed to play with the appliance.
-
The appliance may not be cleaned or maintained by children, unless this is done under supervision.
-
If the appliance is not being used or is being cleaned, switch off the appliance and remove the plug from the socket.
-
Extension cords may only be used if the mains voltage (see the information plate) and capacity are identical to or higher than that of the appliance. Always use an approved earthed extension cord.
-
If you decide not to use the appliance any more due to a defect, we recommend cutting off the cord after removing the plug from the wall socket. Take the appliance to the waste processing department concerned of your municipality.
-
In case of a breakdown, never make repairs yourself; a blown safety device in the appliance could indicate a defect that cannot be remedied by removing or replacing this safety device.
Only original parts should ever be used. -
Never submerge the appliance, cord or plug in water.
-
This appliance is intended for household and similar use, such as:
– in staff kitchens, shops, offices and other work environments;
– by guests of hotels, motels and other residential environments;
– in Bed&Breakfast type environments;
– farms. -
If the appliance is not used as intended, no compensation can be claimed in case of defects or accidents and the warranty will be invalidated.
-
If you decide not to use the appliance any more due to a defect, we recommend cutting off the cord after removing the plug from the wall socket. Small household appliances do not belong in the dustbin. Take the appliance to the waste processing= department concerned of your municipality.
product description
- Cast-iron hot plate Ø 180 mm
- Cast-iron hot plate Ø 150 mm
- Thermostat button (MIN – 1 – 2 – 3 – 4 – 5 – MAX)
- indicator led – right hot plate
- indicator led – left hot plate
- Thermostat button (MIN – 1 – 2 – 3 – 4 – 5 – MAX)
prior to first use
Before using the appliance for the first time, you should proceed as follows:
carefully unpack the hob and remove all packaging material and any promotional
stickers. Keep the packaging (plastic bags and cardboard) out of the reach of
children.
After unpacking the appliance, check it for external damage that may have
occurred during transport.
Place the hot plate on a sturdy, flat and heat-resistant surface. Clean the
hot plate with a slightly damp cloth. The cook plate(s) is/are provided with a
protective layer that must be removed prior to first use. This is done by
turning on the cook plate at maximum level for approximately 4 to 5 minutes.
Light smoke may form due to the protective layer burning off the cook plate.
After removing the protective layer you can switch off the cook plate or start
using it.
use
Make sure the thermostat button is on the «MIN» position before the appliance
is switched on. Insert the plug in the socket.
Turn the thermostat knob to the right, to the required position. The
accompanying indicator led will light up.
Position «MIN» of the cook plate is the lowest position and position «MAX» is
the highest position.
Use a low position [ MIN to 4 ] for simmering and a higher position [ 5 tot
MAX ] for boiling and frying.
The thermostat button is a stepless control.
MIN = low
1-4 = keep warm-simmer
5 = boiling and frying
MAX = high
It takes approximately 10 minutes for the cook plate to reach maximum
temperature (on the maximum setting of the thermostat knob).
When the temperature that belongs to the set position is reached, the
indicator led switches off. After a drop in temperature, heat transfer to the
pan, the thermostat switches on again. The indicator led will light up again.
Due to the construction of the hot plate, it remains hot for some time after
switching off. This residual heat can be used to keep the food warm for a
short period of time.
CAUTION: THE APPLIANCE CAN GET VERY HOT DURING USE, THEREFORE PLACE THE APPLIANCE DURING USE ON A HEATRESISTANT PLATE AND NEVER, FOR EXAMPLE, ON A PLASTIC TABLE, PLASTIC TABLE CLOTH OR REFRIDGERATOR.
Only use pans with bottoms that have the same diameter as the hot plate
itself. Smaller diameters lead to loss of energy.
Do not touch the hot plate when it is switched on. Please note that the hot
plate does not cool down immediately after being switched off. Turn the
thermostat button to the «MIN» position and remove the plug from the socket to
switch off the hot plate and after each use.
cleaning and maintenance
Prior to cleaning, always switch off the appliance and remove the plug from
the wall socket. Allow the hot plate to cool down before cleaning it with a
damp cloth.
The base unit can also be cleaned with a damp cloth or sponge. Do not use
abrasives or other aggressive cleaning agents.
Do remember that the hot plates require some time to cool down after having been switched off.
Do not submerge the appliance in water and/or other liquids.
general terms and conditions of service and warranty
We do not need to remind you of the importance of service. After all, we develop our products to a standard so that you can enjoy them for many years, without any concerns. If, nevertheless, there is a problem, we believe you are entitled to a solution straight away. Hence our products come with an exchange service, on top of the rights and claims you are entitled to by law. By exchanging a product or part, we save you time, effort and costs.
2-year full manufacturer’s warranty
- Customers enjoy a 2-year full manufacturer’s warranty on all Inventum products. Within this period, a faulty product or part will always be exchanged for a new model, free of charge. In order to claim under the 2-year full manufacturer’s warranty, you can either return the product to the shop you bought it from or contact the Inventum costumer service department via the form at www.inventum.eu/service-aanvraag.
- The 2-year warranty period starts from the date the product is bought.
- In order to claim under the warranty, you must produce a copy of the original receipt.
- The warranty applies only to normal domestic use of Inventum products within the Netherlands.
Breakdowns or faults outside the warranty period
- Breakdowns or faults in small or large domestic appliances outside the warranty period, can be reported to the costumer services department via the form at www.inventum.eu/service-aanvraag or by calling the costumer services department.
- The costumer services department may ask you to send the product for inspection or repair. The costs of dispatch will be at your expense.
- The inspection to establish whether repair is possible involves a charge. You need to grant your permission for this, in advance.
- In the event of a large domestic appliance, Inventum, at your request, can send out a service engineer. In that case, you will be charged the call-out costs, as well as parts and labour.
- In the event of an instruction to repair, the repair costs must be paid in advance. In the event of a repair by a service engineer, the costs of the repair must be settled with the engineer onsite, preferably by means of PIN payment.
Warranty exclusions
-
The following is excluded from the aforesaid warranties:
- normal wear and tear;
- improper use or misuse;
- insufficient maintenance;
- failure to comply with the operating and maintenance instructions;
- unprofessional installation or repairs by third parties or the customer himself;
- non-original parts used by the customer;
- use for commercial or business purposes;
- removal of the serial number and/or rating label.
-
In addition, the warranty does not apply to normal consumer goods, such as:
- dough hooks, baking tins, (carbon) filters, etc.;
- batteries, bulbs, carbon filters, fat filters etc.;
- external connection cables;
- glass accessories and glass parts such as oven doors;
- and similar items.
-
Transport damage not caused by Inventum is also excluded. Therefore, inspect your new device before starting to use it.
If you detect any damage, you must report this to the store where you purchased the product within 5 working days, or to the Inventum customer service department via the form at www.inventum.eu/service- aanvraag. If transport damage is not reported within this period, Inventum does not accept any liability in this respect. -
The following are excluded from warranty and/or replacement: faults, loss of and damage to the device as a result of an event that is normally insured under the home contents insurance.
Important to know
- The replacement or repair of a faulty product, or a part thereof, does not lead to an extension of the original warranty period.
- If a complaint is unfounded, all costs arising from it will be at the customer’s expense.
- Following expiry of the warranty period, all costs of repair or= replacement, including administration costs, dispatch and call-out charges, will be charged to the customer.
- Inventum cannot be held liable for damage caused by external events, unless this liability arises from mandatory statutory provisions.
- These warranty and service provisions are governed by Dutch law. Disputes will be settled exclusively by the competent Dutch court
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>