MoTrade AURIS 2014-2019 Carplay Android Auto Interface Instruction Manual
- October 30, 2023
- MoTrade
Table of Contents
AURIS 2014-2019 Carplay Android Auto Interface
Product Information: Carplay Android Auto Interface for Toyota AURIS
2014-2019
The Carplay Android Auto Interface is a device that can be installed in Toyota
AURIS cars manufactured between 2014 and 2019.
The interface is connected to the radio connectors and allows users to easily
connect their smartphones to the car’s system. The installation process takes
approximately 15-30 minutes and does not require any programming.
Product Usage Instructions
Follow the steps below to install the Carplay Android Auto Interface:
- Step 1: Click the panel around the screen. Carefully pull off the front panel and disconnect the connectors. First, unclip the little side panel on the left.
- Step 2: Remove the display (unscrew). Unscrew the screen. In total there are 2 or 4 bolts of 10 mm. Place a blanket on the center console to avoid scratches. Pull the screen towards you.
- Step 3: Prepare the cable. Route the main cable from the glove compartment to the screen (if you want to place it in the glove compartment) or find another place for the interface.
- Step 4: Connect the three connectors. Disconnect the three plugs from the screen/radio. Reconnect them to the cable counter-connectors. Connect the three connectors of the interface cable to the screen/radio.
- Step 5: Reconnect all components. Reconnect all components in reverse order. Don’t forget to plug back in the front panel plugs.
- Step 6: Have fun!
Note: If you have any improvement tips or tricks, please feel free to contact motrade@kpnmail.nl
Installation instruction for Carplay Android Auto interface
Toyota AURIS 201 4-2019
The interface is connected via the connectors of the radio. It is estimated
that it takes 15-30 minutes of work to connect the interface. No programming
is necessary.
Step 1. Click the panel around the screen
Carefully pull off the frontpanel and disconnect the connectors.
(First unclip the little side panel left)
Step 2. Remove the display (unscrew)
Unscrew the screen. In total there are 2 or 4 bolts of 10 mm. Place a blanket
on the center console to avoid scratches. Pull the screen towards you.
Step 3. Prepare the cable
Route the main cable from the glove compartment to the screen (if you want to
place it in the glove compartment) or find another place for the interface.
Stap 4. Connect the three connectors
Disconnect the three plugs from the screen/radio. Reconnect them to the cable
counter-connectors. Connect the three connectors of the interface cable to the
screen/radio.
Step 5. Install the screen/radio
Pull back the screen/ radio and attach the 4 bolts.
Step 6. Test the system
Connect the interface and the USB cable. Read the manual to choose the correct
position of the dip switches. Choose AUX as the source for sound in the
original system. Switch to the interface by long pressing the Siri button,
MODE button, or AUX.
Remove and forget the existing bluetooth connection to the car.
Connect the phone to the bluetooth signal of the interface and turn on WIFI.
The bluetooth connection creates a WIFI network and then disconnects itself.
Test the system with respect to graphics, sound, scchopping between radio and interface and backwards.
Step 7. Reconnect all components
Reconnect all components in reverse order. Don’t forget to plug back in the
front panel plugs.
Step 8. Have fun!
This manual has been compiled on the basis of experience and with the necessary care. No rights can be derived from it. Improvement tips/tricks are of course always welcome! (motrade@kpnmail.nl)
MoTrade April 2023 ©
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>