PHILIPS BRP210 Street Light Instruction Manual
- June 9, 2024
- Philips
Table of Contents
PHILIPS BRP210 Street Light
Product Information
The product is a BRP210 LED luminaire available in 4 different variants. The variants are differentiated based on the number of LEDs and the corresponding wattage, which are as follows:
- BRP210 30LED470 – 30 LEDs with a wattage of 470 W
- BRP210 35LED500 – 35 LEDs with a wattage of 500 W
- BRP210 40LED530 – 40 LEDs with a wattage of 530 W
- BRP210 40LED106 (WW) S – 40 warm white LEDs with a wattage of 106 W
The luminaire is not suitable for storage or usage in environments that contain hazardous gases such as sulfide, halide, phthalate, etc. Additionally, the luminaire should not be used in an ambiance with ethylamine, tetra- dichloroethylene, or any other material that is hazardous to PC material.
Product Usage Instructions
- Connect the power cord to the luminaire.
- Mount the luminaire using screws.
- Tighten the screws alternately and evenly.
- If the gear unit is damaged, replace it with a new one.
Note: Please refer to the product manual for any additional instructions or safety information.
Mounting instruction
- I. Switch off the power before operation.
- The luminaire should be replaced immediately if any crack or deterioration.
- The Luminaire should be installed by a qualified electrician and wired in accordance with the latest IEC-60364-7-714 regulations or the national requirements. I-60364-7-7144525/.
- The connection of the power cable on the luminaire is type Y.
- The light source and power cable contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similarly qualified person.
- The luminaire should avoid storage and usage in such surroundings or an occasion that is with corrosion or hazardous gases like sulfide, halide, phthalate, and so on.
- The PC material cannot be used in such an ambiance that is with ethylamine, tetra-dichloroethylene, which is corrosion or hazardous to PC material, and so on.
Signify (China) Investment Co., Ltd. Building No. 9, Lane 888 Tianlin Road, Minhang District, Shanghai, China Postal code: 200233
Connect the power cord
- Watertight box IP65, the dimension calue must be below the pole arm inner diameter value, to ensure it go through the polearm.
Mount Luminaires
Replace damage gear unit
Disclaimer
- Always use IP65 or higher IP-rated junction box/connector for wiring connection.
- The luminaire should never be used in submerged wet conditions e.g. underwater, soil, snow etc.
- The wiring connection should also never be used in submerged wet conditions eg. water, soil, snow, etc. OR must use an IP68 junction box.
- The warranty is void, in case any of the instructions/guidelines are not followed as per the given mounting instruction.
- This product is not supplied with any junction box/connector.
- For further clarification, please contact the manufacturer.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>