Jandy Never Lube 2 Way CPVC Valve Instruction Manual
- October 30, 2023
- Jandy
Table of Contents
Never Lube 2 Way CPVC Valve
Instruction Manual
Never Lube 2 Way CPVC Valve
WARNING
FOR YOUR SAFETY – This product must be installed and serviced by a contractor
who is licensed nd qualified in pool equipment by the jurisdiction in which
the product will be installed where such state or local requirements exist.
The maintainer must be a professional with sufficient experience in pool
equipment installation and maintenance so that all of the instructions in this
manual can be followed exactly. Before installing this product, read and
follow all warning notices and instructions that accompany this product.
Failure to follow warning notices and instructions may result in property
damage, personal injury, or death. Improper installation and/or operation will
void the warranty.
PLUMBING
One valve is designed for both 1½” and 2” pipe. 1½” pipe slip fits into valve
ports. 2” pipe is joined using 2½” pipe coupler. 45° or 90° fitting. See
drawing on this page. Internal valve assembly must be removed prior to gluing
valve body to pipe fittings. Make certain no glue enters valve body beyond the
ports. WELD-ON ®724 CPVC GRAY IS RECOMMENDED.
VALVE HANDLE USE
Lock Knob – Loosen lock knob to turn handle. To secure handle, turn knob down
finger tight. See drawing on this page.
Off Indicator – OFF area on indicator represents exact position of internal
valve diverter seal.
Handle Stops – Protruding pins
located on valve cover will stop
diverter in complete port shutoff position. Be sure the word “INLET” on valve
cover is over the incoming flow port.
Valve Complete, Positive Seal Part #4724
| Item No | Part No | Description | Qty |
|---|---|---|---|
| 1 | 1298 | #14 x 3/4” Valve Housing Screw | 8 |
| 2 | R0486900 | Knob (ABS) Black | 1 |
| 3 | R0487200 | Valve Handle Never Lube | 1 |
| 4 | 4734+ | Valve Cover (2-Port) Black | 1 |
| 5 | 1132+ | 151 O-Ring | 1 |
| 6 | R0487100 | 116 O-Ring | 2 |
| 7 | 4720 | Diverter Assembly Complete (Positive) Never Lube ® | 1 |
NOTE The valve housing is not available as a separate part. To replace the valve housing, you must replace the
Item #7. Diverter Assembly Complete with Knob
NOTE Item 7 (Part 4720) includes a Pipe Plug P-18, but you can discard it,
because it is not needed with this valve.
Zodiac Pool Systems LLC
2882 Whiptail Loop East #100, Carlsbad, CA 92010
1.800.822.7933 | www.Jandy.com
©2019 Zodiac Pool Systems LLC. ZODIAC
is a registered trademark of Zodiac
International, S.A.S.U., used under license. All trademarks referenced herein
are the
property of their respective owners.
4736 Rev F
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>