Tell Manufacturing 7300 Series Rim Device Instruction Manual
- October 30, 2023
- Tell Manufacturing
Table of Contents
Tell Manufacturing 7300 Series Rim Device
Installation Instructions 7300 Series Rim Device
The screws (from item B to E), attach both machine & tapping screws for install selection in the accessory package.
How to determine hand of door
PARTS LIST
Installation Instructions F7300 Series Rim Device
The screws (from item B to D), attach both machine & tapping screws for install selection in the accessory package.
How to determine hand of door
PARTS LIST
7300 & 7300 Series Rim Device
If necessary, add strike shim kit under strike for¾ 5″ (4.8mm) as dimension shown
- STEP 1 MARK CENTER LIN ES
- STEP 2 PREPARE INSTALLATION:
- STEP 3 CUT DEVICE IF NECESSARY
- Device length A must be at least 1½” (38mm) shorter than B
- If necessary cut device so A is at least 11″ (38mm) shorter than B 0
- Standard Door Stop is 5/8″(15.9mm). Install 1/8″(3mm) thick shim if necessary
- Device length A must be at least 1½” (38mm) shorter than B
- STEP 4: MOUNTING DEVICE
- Take off head cover and then put device horizontally at the door. Fix screws (B) on chassis but DO NOT tighten them at this step.
- lnstall bracket. Be sure to remain device being horizontal and then tighten all screws.
- lnstall end cap & head cover.
TEMPLATE FOR 7100 / F7100 RIM DEVICE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>