Tell Manufacturing LC1200 Series Locks Instruction Manual

INSTALLATION INSTRUCTION
LC1200/LC2400 SERIES LOCKS

HOW TO INSTALL THIS CYLINDRICAL LEVERSET
LEVERSET IS SET FOR 1 3/4” THICK DOOR – BACKSET 2 3/4”

New Door Preparation

1. Fold template over edge of door and mark holes.

2.  Drill a 2-1/8″ hole.

3.  Drill two 3/8″ thru bolt holes through face of door.(only if the thru bolts are being used).

4.  Drill a 1″ hole in edge of door.

5.  Cut 5/32″ notches on 2-1/8″ hole on both sides of door.
   (very important if not using thr u bolts)

6. Mortise latch unit front
   2-1/4″ x 1-1/8″ x 1/8″ for 2-3/4″ backset or 2-1/4″ x 1″ x 1/8″ for the optional 2-3/8″ backset

DISASSEMBLE INSIDE LEVER

1A: Insert push pin into hole to depress catch and remove the lever.

INSTALL LEVERSET TO DOOR

2A: Insert latchbolt and secure with combination screws.

2B:Place lock body into position. Make sure that latch prongs engage chassis in housing, and slide engages latch tail.

2C:Install inside spring cage , Screws should be hand tightened all the way down with a screwdriver.

INSTALL STRIKE

INSTRUCTIONS FOR REMOVING AN INSTALLED LOCK FROM THE DOOR

INSTRUCTIONS FOR ADJUSTING LOCK TO FIT DOOR THICKNESS OTHER THAN 1-3/4″

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>