BLAUPUNKT GTA 1465 Power Amplifier Instruction Manual

BLAUPUNKT GTA 1465 Power Amplifier Instruction Manual

CAUTIONS

Proper system planning is vital in order to maximize the device’s performance and road safety. Plan your installation carefully to avoid compromising performance reliability of the system. Consult an authorized Blau punkt dealer for installation or repara-tion. Read the manual carefully before operating the device for the first time.

Safety Notes

Ensure to follow below safety notes during installa-tion and wiring connection: –

• Disconnect the negative terminal of the battery. Refer to the safety notes of the vehicle manufactur-er.
• Ensure positions of the holes are nowhere near the vehicle component to avoid any damage during drilling.
• Ensure cross section of the cable is no less than 2.5mm7 if the positive and negative cables are too long.
• Incorrect installation may result in malfunction of the device or the car sound system.

Installation and Connection Instructions

• Select a dry and well-ventilated location to install the device.
• The device must not be installed in overly exposed location such on therear shelf, rear seat etc.
• The installation location must be suitable for screw holes and have stable ground support.

Integrated Fuse
The integrated fuse in the device protects the output voltage and the entire electrical system in case of malfunction. Do not replace damaged fuse with higher current.

Disclaimer
In no event shall Blaupunkt be liable for any direct, indirect, punitive, incidental, special consequential damages to property or life and whatsoever arising out of or connected with the use or misuse of our products.

USA & CANADA: This product is not intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased on as-is basis. No warranty, whether expressed or implied is provided in the U.S. or Canada.

General Safety Notes
Observe the following to protect yourself against injuries :

• The supply voltage requirement is 12V DC with grounded negative connection. Unauthorised dismantling or modifying may void the warranty of the device. Blaupunkt is not liable for any loss or damaged caused or resulting from unauthorized reparation or modification to the device. Refer to a Blaupunkt specialist in case of any installation or reparation required.
• The device’s core components may be damaged when the car is driven on bumpy roads for a prolonged period of time or if it is used to play non-standard volume level.
• Please do not operate the car radio under extreme temperature conditions (extremely high tempera-ture or extremely low temperature); ensure the temperature within the car ranges from -10°C to 85°C (Storage temperature : 5°C to 35°C) before connecting to the power supply.
• For abnormalities, please refer to TROUBLESHOOT-ING. Consult a specialist if the problem persist.
• Solvents, cleaning and scouring agents as well as dashboard spray and plastics care products may contain materials which can damage the surface and screen of the device. Use only dry or slightly moistened cloth to clean the device.

Recycling and Disposal

Do not dispose of your old unit in the household trash!
Use the return and collection systems available to dispose of the old device.

This manual may be updated from time to time without any notice. Visit www.blaupunkt.com for more info.

INPUT FUNCTION

1. PRO/PWR Indicator
2. HPF Control
3. Crossover (HPF/FULL/LPF)
4. CH1/ CH2 Gain Control
5. Input
6. Output
7. CH3/ CH4 Gain Control
8. Bass Boost
9. LPF Control
10. Power
11. Fuses
12. 4 Channel Speaker Output

SPECIFICATION

Power

• Voltage Supply : 11-16V DC
• Idling Current : 0.6A
• Fuse : 30A x 2
• Consumption @ 20, 14.4 VDC : 40A (Max Musical Power)

Amplifier

• Amplifier Class : CLASS AB
• Channel: 4/3/2
• PCB Layer : 1
• Max Output Power @ 4 ohms : 130W x 4
• RMS Power 4 ohms : 65W x 4
• RMS Power 2 ohms : 85W x 4
• RMS Power 4 ohms Bridge : 160W x 2
• Signal-To-Noise Ratio : >96dB
• Frequency Response : 10Hz – 45kHz
• Gain Adjust : 180mV – 8V
• Bass Boost Frequency : 39-59Hz
• Bass Boost Level : 0-12dB
• Total Harmonic Distortion : <0.1%
• Crossover Frequency : 32Hz – 300Hz (L); 35Hz – 500Hz (H)
• RCA Input : 4 Channel
• RCA Output : 2 Channel
• Dimension (W x H x D): 320 x 200 x 57mm
• Net Weight : 2.71 kg

Accessories

2x Fuses

2x Toolkits

4x Srews Lthel Amml

4x Gaskets

4x Spring Gaskets

WIRING DIAGRAM

Stereo Mode

Speaker Connections

Bridged Mode

Power Connection Leads

WARNING Do not connect negative charge of the battery to the positive charge before installation.

TROUBLESHOOTING

If any of the following problem occur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt authorized dealer if problem persist.

and repair accordingly.
Fuse failed to work| Examine power integrity and reversed polarity, repair or replace fuse accordingly.
Disconnected power wires| Examine power wire and ground connections.
Replace and repair accordingly.
Missing output from source or audio input not connected| Examine input connection and signal integrity.
Replace or repair accordingly.
Unstable audio cycle| Disconnected speaker wires| Examine speaker wires.
Replace or repair accordingly.
Broken speaker| Examine radio system.
Replace or repair accordingly.
Thermal protection will be activated when amplifier temperature exceeds 90°C| Improve amplifiers ventilation accordingly.
Poor audio Input| Examine input connection.
Replace or repair accordingly.
Audio distortion| High amplifier sensitivity setting, exceed maximum output capability of amplifier| Refer to manual to reset gain setting.
Low impedance| Examine speaker impedance. Rewire speaker accordingly, if below 20 stereo or 40 mono.
Improper connection of speaker and amplifier| Examine speaker wire, replace or repair accord-ingly.
Broken speaker| Refer to manual for installation instruction.
Examine radio system.
Poor bass response| Wrong speaker wire polarity connection causing phase cancella- tion| Replace or repair accordingly.
Examine speaker polarity and repair accordingly.
Broken battery fuse| Low impedance| Examine speaker impedance. Rewire speaker accordingly, if below 20 stereo or 40 mono.
Incorrect power connection| Examine power wire and ground connections.
Repair accordingly.
Fuse used is smaller than reconi- mended| Replace with recommended fuse type.
Over drawn current| Examine speaker impedance. Rewire speaker and replace fuse accordingly, if below 20 stereo or 40 mono.
Incorrect power wire| Examine power wire and ground connections.
Repair accordingly.
Broken amplifier fuse| Over drawn current| Examine speaker impedance. Rewire speaker and replace fuse accordingly, if below 20 stereo or 40 mono.
Fuse used is smaller than recon–i- mended| Examine power wire and ground connections and repair accordingly with correct fuse.

Blaupunkt Car Entertainment – Asia Pacific Competence Centre

Documents / Resources

| BLAUPUNKT GTA 1465 Power Amplifier [pdf] Instruction Manual
GTA 1465 Power Amplifier, GTA 1465, Power Amplifier, Amplifier
---|---
| BLAUPUNKT GTA 1465 Power Amplifier [pdf] Instruction Manual
GTA 1465 Power Amplifier, GTA 1465, Power Amplifier, Amplifier

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>