tommee tippee Steri Dryer Electric Steam Steriliser and Dryer Instruction Manual
- June 10, 2024
- Tommee Tippee
Table of Contents
STERIS Dryer Electric Steam Sterilizer and Dryer
Instruction Manual
steridryer
electric steam sterilizer and dryer
instructions for use
STERIS Dryer Electric Steam Sterilizer and Dryer
IMPORTANT WARNINGS!
These instructions can also be found at
www.tommeetippee.com
Keep this instruction leaflet for future reference as it includes important
information.
This appliance is intended for household use only. Do not use outdoors. Before
plugging in the Sterilizer and Dryer for the first time ensure that the
voltage is compatible with your electricity supply by checking the label on
the base of the unit.
Ensure water has been added to the unit before switching the unit on. Do not
immerse in water, to protect against fire, electric shock and injury to
persons. Do not immerse cord, plugs or other parts of the unit in water or
other liquid. Misuse of the product may result in the risk of fire, electric
shock and/or personal injury.
This appliance shall not be used by children. Keep the appliance and its cord
out of reach of children. Appliances can be used by persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance.
User maintenance other than cleaning and descaling is not required for this
product. Cleaning and user maintenance shall not be made by children.
The heating element surface is subject to residual heat after use.
Do not touch hot surfaces use handles and knobs.
When in use the Steriliser and Dryer contains hot water and steam.
Keep hands away from steam vents as it can cause burns and scalds. Use in a
well ventilated area.
Do not operate any appliance with a damaged cord, plug or after the appliance
malfunctions or has been damaged in any manner.
If the supply cord is damaged it must be changed by a qualified person in
order to avoid a hazard.
Always use on a flat heat resistant surface.
Do not move appliance when in use.
Do not let the cord hang over edge of kitchen work surface or touch hot
surfaces.
Do not use any accessories other than those supplied with this appliance.
PARTS GUIDE
HOW TO REPLACE THE FILTER
It is recommended to change the filter every 6 months.
The filter is found on the underside of the sterilizer base (j).
To change the filter:
1. Unclip the filter panel door (k) and remove old filter.
2. Place the filter (l) into the sterilizer base, making sure that the tab
handle is still visible on top of the filter (m).
3. Place the filter panel door back onto the sterilizer base (j).
CONTROL PANEL
BEFORE FIRST USE
You must insert the filter provided into the underside of the sterilizer base
before you start using the sterilizer and dryer.
USAGE
It is important that all bottles, teats and accessories are empty and that
they are clean and fully rinsed in fresh water before placing in the appliance
for sterilization.
Use on level surface and be sure there is no debris under the unit and the
rubber pads are touching the surface.
This steriliser is designed for use with Tommee Tippee bottles and feeding
accessories (except bottle brush).
The sterilizer will hold a maximum of 6 Tommie Tipped Closer to Nature bottles
(maximum 4 Advanced Anti-colic bottles) or a combination of fewer bottles plus
soothers and breast pump parts.
Remove the lid (a) and the racks (b), (c) from the sterilizer base (d). Pour 120ml of water onto the stainless steel heater surface (do not go over the max fill line (h)). If using dry only function you do not need to add any water.
Insert lower rack (c), place clean bottles with their opening facing downward onto the lower posts. Place hoods onto the bottle bases.
Insert the upper rack (b) and place in the bottle accessories (eg. teat and screw ring).
Place the lid (a) on top. Please ensure that the lid fits securely onto the upper rack without any gaps.
Plug the sterilizer into the power outlet. Press the on/off button. The sterilizer will emit a “beep” sound and the button will light up. Choose your desired function following the instructions on the next page.
CHOOSE YOUR FUNCTION
STERILISE AND DRY
-
Press the Automatic sterilize and dry button once. The appliance will beep once and the sterilization cycle will start. The sterilizing time is approximately 10 minutes.
-
When the sterilizing cycle is complete, the drying cycle will follow automatically.
The drying time is approximately 30 minutes. -
When the drying cycle is complete, the appliance will beep 5 times and power off automatically. Please allow to cool for at least 5 minutes before opening the sterilizer.
STERILISE ONLY
- Press the sterilize button once. The appliance will beep once and the sterilization cycle will start. The sterilizing
- When sterilization cycle is complete, the appliance will beep 5 times and switch off automatically. Please allow to cool for at least 5 minutes before opening the sterilizer.
CAUTION!
If you need to drain water from the base, always pour sideways away from the
air vent in the direction marked inside the base.
DRY ONLY
- Press the dry button once. The appliance will beep once and the drying cycle will start.
- The drying cycle is approximately 30 minutes.
- When the drying cycle is completed, the appliance will beep 5 times and switch off automatically. Please allow to cool for at least 5 minutes before opening the sterilizer.
Please note: The sterilization and/or the drying cycle can be stopped any
time by pressing the on/off button.
CLEANING
Unplug and allow to cool before cleaning. After each use pour away remaining
water from the sterilizer base by tipping the sterilizer and dryer sideways
over a sink, ensuring no water gets into the air vent (i), and wipe clean
with a damp cloth only. The lid (a) and the two racks (b, c) can be cleaned in
hot water. Do not clean with abrasive cleaners.
WARNING!
TO AVOID THE RISK OF ELECTRIC SHOCK, INJURY OR DAMAGE: ALWAYS UNPLUG YOUR
PRODUCT BEFORE CLEANING. DO NOT IMMERSE THE BASE, THE SUPPLY CORD OR THE PLUG
IN WATER OR OTHER LIQUIDS. DO NOT CLEAN BASE UNDER WATER TAP.
DO NOT use metal objects or scourers to clean your Sterilizer and Dryer. DO
NOT use bleach or sterilizing fluid to clean it. DO NOT use abrasive or
antibacterial materials. DO NOT scrub the heat plate.
CAUTION! UNDER NO CIRCUMSTANCES USE ABRASIVE, CORROSIVE OR SCRATCHING
CLEANING AGENTS, AS THESE COULD DAMAGE YOUR STERILISER.
Please note: If there is insufficient water to complete the sterilization
phase effectively, the appliance will ‘”beep” 5 times and the function light
will flash for 2 hours. Do not use the bottles or accessories. Repeat usage
instructions to ensure effective sterilization. Drying time based on 260ml /
9oz bottles. If you are using larger bottles, then extra drying time may be
required.
DE-SCALING
The guide below shows what the frequency of de-scaling should be.
Hard water: 14 days
Medium: 21 days
Soft: 28 days
You can find out your water quality from your water provider.
Unplug the unit and allow to cool before descaling. After each use pour away
remaining water from the unit base by tipping the unit sideways over a sink
and wipe with a damp cloth only. We recommend that you descale your appliance
according to the guidelines above to ensure that it continues to work
efficiently. Living in a hard water area can produce limescale quicker than
other areas so descaling is required sooner. Use a descale that is suitable
for use with stainless steel and use as per the manufacturer’s guidelines. Or
you can use white vinegar or a descaling sachet to descale your unit. Please
use as per manufacturer’s guidelines. Where no method is stated, 1:4 descale
to water ratio can be applied.
TROUBLE SHOOTING
This information can also be found at tommeetippee.com
| CONDITION | POSSIBLE CAUSE | REMEDY |
|---|---|---|
| Machine will not start | Appliance is unplugged | Make sure the plug is securely |
inserted into the power outlet and power is turned on
Appliance is not turned on| Press on/ off button before choosing function
Scaling on the stainless steel heater surface| Limescale| Descale Unit
White marks on bottles| Limescale| Descale Unit
INFORMATION ON THE DISPOSAL FOR WASTE ELECTRICAL & ELECTRONIC EQUIPMENT
(WEEE)
This symbol on the products and accompanying documents means that used
electrical and electronic products should not be mixed with general household
waste. For proper disposal for treatment, recovery and recycling, please take
these products to designated collection points where they will be accepted on
a free of charge asks. In some countries you may be able to return your
products to your local retailer upon the purchase of a new product. Disposing
of this product correctly will help you save valuable resources and prevent
any possible effects on human health and the environment, which could
otherwise arise from inappropriate waste handling. Please contact your local
authority for further details of your nearest collection point for WEEE.
Penalties may be applicable for the incorrect disposal of this product in
accordance with national legislation.
The product is fitted with a mains plug containing a fuse (10A). If it ever
becomes necessary to replace the fuse, only use fuses that are marked AC250V,
and rated at 10A. In the unlikely event that this plug is not suitable for
the sockets in your home, it should be removed and a suitable plug fitted as
follows: The wires of the mains lead are cultured in accordance with the
following code:
GREEN AND YELLOW – EARTH
BLUE – NEUTRAL
BROWN – LIVE
As these coolers may not correspond with the cultured markings sometimes used
to identify the terminals in the plug, connect as follows.
The wire cultured GREEN AND YELLOW must be connected to the terminal marked E
or by the earth symbol or cultured GREEN or GREEN AND YELLOW. The wire
cultured BLUE must be connected to the terminal marked N or cultured BLACK.
The wire cultured BROWN must be connected to the terminal marked L or cultured
RED.
If you are in any doubt about how to wire a plug or replace a fuse safely,
consult a qualified electrician.
May born (UK) Limited,
Balliol Business Park, Newcastle upon Tyne, NE12 8EW, UK
EU Representative
May born France Snarl, 56 Rue de Paris,
Boulogne Bullecourt, 92100 France
All IP rights held by May born (UK) Limited and/or its affiliates.
TOMMEE TIPPEE ®. Copyright © 2022.
Made in China.
Model number: WX-965D.
Voltage: AC220-240V~ 50-60Hz 600W
0423224 12121022_1 (Any questions?
Visit our website:
tommeetippee.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>