amino Keep-It Kit Instructions

: June 10, 2024
: amino

Table of Contents

Keep-It Kit
Safety Note:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Keep-it Kit™
Instructions: preserve your petri dishes

Keep-It Kit

In your kit: amino Keep-It Kit -Fag 1

The resins are clear, these colors are for illustration only.

You will also need:

Choose up to 3 Petri dishes you want to preserve and place them right-side-up on a clean surface once you are done incubating them. Take the petri dish lids off if your environment is free of molds; otherwise, leave them closed. Wait for the surface of the Petri dishes to ‘dry’ for 24 – 48hrs.
→ No water/moisture should be visible on the surface when you start step 2. A good way to tell if it is dry enough is to see if the thickness of the agar has shrunk by about half of what it was.
Put on your gloves and set down used paper or cardboard to protect your work surface. → if your resin got too cold in storage or transport, some crystals may have formed in one of the resin pouches. If it looks white or opaque, set it in a cup of hot water until it turns clear again, about 1 minute.
Fold down the sides of the mixing bag so that it resembles a cup.
Add both resin pouches into the mixing bag and close the mixing bag tightly. → you can cut open a corner of the resin pouches or use the lid.
Mix the resins by massaging the mixing bag for 1 to 2 minutes until the liquid looks clear (no more white streaks or ﬁlament). Mixing well is the key
to a good resin, but it will start to solidify after ~5 minutes, so be quick!
Remove the lid of your Petri dishes if needed. Pinch a bottom corner of the mixing bag to clear away the resin and cut a small opening. → Don’t make the opening too large, as the resin is liquid and can pour out too fast.
Pour a quarter-size amount of mixed resin into the middle of one petridish and tilt the petridish around so that the resin covers the entire surface and touches the edges. → You do not need a thick coat of resin; you only need to cover the entire surface of the petridish. If you are preserving 2 or 3 Petri dishes, pour some resin on each petri dish and spread it around by tilting the Petri dishes. Top up each petri dish with any leftover resin. The resin will stay liquid for 5 minutes once mixed.
Leave the resin to set at room temperature over the next 24 hours.
Fill out the information on your petri dish stand using a marker and display your result proudly! If your bacteria is ﬂuorescent, you can still use a black light to see it ﬂuoresce.→See howt oplace your petri dish in the stands here: https://www.youtube.com/watch?v=xHjHryopDhM

amino Keep-It Kit -Fag 5

Safety Note:

Wear gloves at all times and use the kit in a well-ventilated area with adult supervision. If you think you are likely to get some resin on your clothes, wear an apron, lab coat, or old clothes. Remember your Practicing Safe Science: www.amino.bio/safe-science.
The individual kit can preserve up to 3x 6 cm diameter petri dishes (or 1x 10 cm petri dish). The Group kit is made up of 8x individual kits, so enough to preserve a total of 24 small petri dishes (or 8 large ones).