OZOTECH DI Dryer 2.0 Air Dryer User Manual
- June 10, 2024
- OZOTECH
Table of Contents
DI Dryer 2.0
Installation and Operation Manual
THEORY OF OPERATION
The Desiccant Indicating (DI) Dryer is designed to provide minimum dry air protection for small ozone generator applications. The DI Dryer can be used either in a negative or positive pressure application. The blue moisture indicating media absorbs and retains moisture, turning from blue to pink as it becomes saturated.
INSTRUCTIONS
-
Mount the DI Dryer 2.0 in an area close to the ozone generator.
a. Use appropriate anchors and fasteners applicable to the substrate to which the dryer will be mounted. -
Remove the vinyl caps from the inlet and outlet barbs.
-
Attach an appropriate length of clear tubing (provided) from the dryer cap ‘outlet’ port to your airflow meter’s ‘inlet’ connector. If no airflow meter is used, connect the tubing directly to the ‘air inlet’ port of your ozone generator.
a. If using your air dryer in a positive pressure manor, connect an appropriate amount of clear tubing (provided) from your air compressor ‘outlet’ line to the ‘inlet’ port of your dryer.
Reference Figure 1 for typical use -
Follow the manufacturer’s instructions for proper installation of the ozone generator and be sure to carefully follow the “Venturi Injector stall/Calibration Guidelines” document. This document is provided with select ozone generators and is also available for online download at ozotech.com/support.
SERVICING THE DESICCANT MEDIA
The desiccant media may be regenerated when it turns pink. To perform media regeneration, scan the following QR code and follow the regeneration process:
https://qrco.de/DesiccantRegeneration
REPLACING THE MEDIA CARTRIDGE
In place of regenerating the media, pre-filled replacement cartridges may be
purchased to ensure maximum dryer service time.
Use the following part number and model description when ordering replacement
cartridges from Ozotech, Inc. or an authorized equipment dealer 32099 – DI
Dryer 2.0 Replacement Cartridge
Use the instructions and figures below for media cartridge replacement:
- Unscrew the DI Dryer 2.0 cartridge housing from the cap and remove the media cartridge.
- Remove the sealing plug and label from the top and bottom of the replacement cartridge. Install the new media cartridge into the cartridge housing.
- Screw the cartridge housing onto the cap and return the DI Dryer 2.0 to service.
M43-30078 REV A
Ozotech, Inc. • 1015 South Main Street, Yreka, CA 96097 • Ph. 530.842.4189 •
ozotech.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>