LANCOM LX-6500 Wall Mount Instruction Manual
- June 10, 2024
- LANCOM
Table of Contents
Mounting Instructions
LANCOM Wall Mount
LX-6500(E)
Instruction Manual
General notes
The LANCOM Wall Mount LX-6500(E) is intended exclusively for mounting a LANCOM
LX-6500(E) access point in a vertical wall or horizontal ceiling installation.
The bracket must be mounted on a solid, non-bendable / non-stretchable
surface.
Mounting on (roof) slopes or corrugated roofs, as well as installation in
other mounting directions or angles, is not permitted or recommended without
additional securing of
the access point to the bracket.
The bracket is fastened using 4 screws ➁ in the corners of the bracket or 2
screws ➂ on the sides of the bracket.
Preparing the Wall Mount LX-6500(E) for wall mounting
For wall mounting, the bracket must be aligned so that the latching spring ➀
is at the top.
Preparing the Wall Mount LX-6500(E) for ceiling mounting
Basically, it is mandatory to secure the access point in ceiling mounting with
at least one separately available Pennington lock and/or LANCELOT Lock and a
padlock.
When mounting on a flat ceiling, use only the four outer holes ➁ for
fastening.
When mounting with LANCELOT T-Bar Mount (LN) (e.g. on suspended ceilings),
make sure that only the two outer holes ➂ are used for mounting.
Mounting the Wall Mount LX-6500(E)
Use the Wall Mount LX-6500(E) as a drilling template.
Select the appropriate mounting holes ➁ or ➂ depending on the mounting type
and location.
Attaching the access point
When positioning the access point, guide the cables upwards out of the access
point housing.
As shown in the illustration, push the access point onto the Wall Mount
LX-6500(E) as far as it will go.
Then press the access point down until it audibly clicks into place.
Securing the access point
Secure the access point using the separately available LANCOM Lock and
padlock.
As shown in the illustration, insert the locking device into one of the holes
provided when open. Connect the housing and Wall Mount LX-6500(E) by pressing
both halves of the LANCOM Lock together. Make sure that both holes of the lock
are aligned.
Finally, secure the LANCOM Lock with the enclosed padlock.
Removing the access point
To detach the device from the Wall Mount LX-6500(E), please remove the padlock
and LANCOM Lock first. To do this, carry out the previous steps in reverse
order.
Release the lock using a tool (e.g. screwdriver). Push the tool in the
direction of the wall and hold it in this position. Disconnect the Wall Mount
LX-6500(E) by first pushing the access point upwards and then pulling it off
towards the front.
LANCELOT, LANCELOT Systems, COS, LAN community and Hyper Integration are registered trademarks. All other names or descriptions used may be trademarks or registered trademarks of their owners. This document contains statements relating to future products and their attributes. LANCELOT Systems reserves the right to change these without notice. No liability for technical errors and/or omissions. 111410 04/23
LANCELOT Systems GmbH
Adenauer. 20/B2
52146 Undersell | Germany
info@lancom.de
www.lance-systems.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>