REDARC 22MY Next Generation Ford Ranger Instruction Manual
- June 10, 2024
- REDARC
Table of Contents
REDARC 22MY Next Generation Ford Ranger Instruction Manual
These instructions relate to the installation of the REDARC Tow-Pro Elite into
a 22MY Next-Gen
Ford Ranger using the REDARC Tow-Pro Ford Ranger wiring kit.
These instructions only cover the differences in mounting the main unit and
remote head. For all other installation instructions, please refer to the Tow-
Pro Ford Ranger wiring kit instruction manual.
MAIN UNIT MOUNTING
-
Fit the Tow-Pro mounting bracket to the main unit and bend down 90 degrees as shown, close to the fitting.
-
Fit the main unit to the left-hand side of the glove box using the supplied M6 nut and bolt, in the location indicated.
REMOTE HEAD POSITIONING
Bi-turbo model
Remove the gearshift trim (shaded in image). Please note; the clips can be difficult in the front corners (indicated by the dotted circle). Remove the three fixings exposed to lift the complete panel to fit the remote head. Bi- turbo model shown.
Standard model
The complete panel can be removed in a single piece.
For guidance on where to mount the remote head, see the remote head
positioning template on the following page.
Please note, the below image is not to scale.
Please note; the template was produced from a Bi-Turbo model installation. Applications with manual transmission or other trim options may have slight differences and the mounting of the remote head is up to the installer.
FORD RANGER 22MY REMOTE HEAD DRILLING TEMPLATE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>