JMTek BTE200 TWS Wireless Earbuds Instruction Manual
- June 10, 2024
- JMTek
Table of Contents
JMTek BTE200 TWS Wireless Earbuds
BTE200 TWS Earbuds Instruction Manual
Please read the following carefully before using this device to ensure safe
and proper usage.
Package Content
- 1 TWS earbuds
- 1 USB Charging Cable
- 1 User Manual
Specifications
- Type-C input: 5V/300mA
- Bluetooth range: 10M
- Earbud’s battery: Li-polymer 35mAh*2
- Charging case battery: Li-polymer 300mAh
- Charging method for earbuds: Magnetic Sensor Point
- Charging current for earbud: 35mA
- Speaker horn: 10mm 160
- SNR: 80db
- Frequency response: 20Hz-20KHz
- Charging time: 1.5 – 2 hours
- Playing time: 2 – 3 hours
instructions
Wearing View
Safety information
- Do not drop or cause an impact on the device.
- Do not disassemble, modify or repair your device.
- Keep away from humidity and heat.
- Keep it beyond the reach of children.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>