Metra 99-9301 Dash Kit Instruction Manual
- June 10, 2024
- Metra
Table of Contents
99-9301 Dash Kit
Instruction Manual
KIT FEATURES
▶DIN head unit provisions
KIT COMPONENTS
Radio Housing
TOOLS REQUIRED
Torx-head screwdriver
ALL VEHICLES
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the volume knob. Using a T-10 torx-head screwdriver, turn the release lever under the shaft 90º. Leaving the screwdriver in position, pull out on the bottom of the factory head unit and remove the unit. Disconnect the wiring. Using a T-10 torx-head screwdriver, loosen (2) T-10 torx-head screws located beside the head unit guides and remove the top of the factory head unit. Disconnect the wiring.
Snap the into the dash opening.
Locate the factory wiring harness in the dash. Metra recommends
using the proper mating adaptor and making connections as shown.
(Isolate and individually tape off the ends of any unused
wires to prevent electrical short circuit).| Slide the DIN cage into the dash
cavity and
secure by bending the metal locking tabs down.
Slide the aftermarket head unit into the DIN cage until secure. Re-connect the battery terminal and test the unit for proper operation.
rev. 06-18-07
1-800-221-0932
www.metraonline.com
© COPYRIGHT 2001-07 METRA ELECTRONICS CORPORATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>