ESi U24 XL Driver Under Windows XP User Guide
- June 11, 2024
- ESi
Table of Contents
Knowledge Base
Installation of the U24 XL driver under Windows
original release: 2012-04-19
ID: KB00014EN
User Guide
Introduction
The U24 XL driver can be used under Windows XP, Vista and 7/8, both in 32-bit
and 64-bit systems. Depending on the OS version, the installation procedure is
slightly different. The following text first explains the installation under
Windows Vista and Windows 7/8 , followed by the installation under Windows XP
, each in a different section. Please only check the corresponding section for
your operating system.
Installation under Windows Vista and Windows 7/8
Before the actual installation, download and unzip the driver file. Make sure
that U24 XL is notconnected to your computer before you install the driver.
Then launch setup.exe from the unzipped folder. When launching the
installation, Windows Vista or Windows 7/8 might prompt a security message.
Make sure to allow the installation. You will then see a dialog as shown on
the following picture.
Click Next. You can define the target
directory for the installation in the following dialog.
Confirm it with Next. The installer now informs you that the
driver installation will start as shown below.
Confirm this with Next. During the
following process you will see a Windows Security dialog box that asks you for
confirmation to install the driver software that looks like this:
Confirm any such dialog with Install even if it gets displayed
multiple times . You will then be prompted to connect the hardware in the
dialog shown below.
Plug in U24 XL but do not click OK
yet. Instead, wait a few seconds for the automatic device driver installation.
You can monitor this in the task notification area where Windows Vista or
Windows 7/8 usually informs that the driver is installed via a bubble message
box.
Once Windows shows no further messages, the installation is finished and you
can start using U24 XL in your applications.
Installation under Windows XP
Before the actual installation, download and unzipthe driver file. Make sure
that U24 XL is not connected to your computer before you install the driver.
Then launch setup.exe from the unzipped folder. You will then see a dialog as
shown on the following picture.
Click Next. You can define the target
directory for the installation in the following dialog.
Confirm it with Next. The installer now informs you that the driver
installation will start as shown below.
Confirm this with Next.
During the following process you will see a Software Installation dialog box
that asks you for confirmation to install the driver software that looks like
this: Confirm any such dialog with Continue Anyway even if it gets displayed
multiple times . You will then be prompted to connect the hardware in the
dialog shown below. Plug in U24 XL but do not click OK yet. Instead, wait a
few seconds for the automatic device driver installation. During the actual
driver installation, you will see the following Hardware Installation dialog
box: Confirm any such dialog with Continue Anyway even if it gets displayed
multiple times . Once Windows shows no further messages, the installation is
finished and you can start using U24 XL in your applications.
Copyright © 1998-2023 ESI Audiotechnik GmbH
All rights reserved.
www.esi-audio.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>