ESI Audio UGM96 Treibers Unter Windows Instructions

: May 15, 2024
: ESI Audio

Table of Contents

Introduction
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Audio UGM96 Drivers Under
Windows Instructions
ID: KB00017EN

Introduction

The driver of UGM96 can be used under Windows XP, Vista and 7/8, both in 32-bit and 64-bit systems. Depending on the OS version, the installation procedure is slightly different. The following text first explains the installation under Windows Vista and Windows 7/8, followed by the installation under Windows XP, each in a different section. Please only check the corresponding section for your operating system. There are also videos for each system at the end of the article. This description is valid up to version 3.0 of the driver. For later versions, check this article.

Installation under Windows Vista or Windows 7/8

Disconnect UGM96 before you install the driver if it has been connected already. Then launch setup.exe from the Windows folder of the included Installation CD or from a download of a recent driver from our website after unzipping the downloaded file.
When launching the installation, Windows Vista / 7 / 8 might prompt a security message. Make sure to allow the installation. You will then see a dialog as shown on the left picture below. Click Next . You can define the target directory for the installation now. Confirm it with Next . ESI Audio
UGM96 Drivers Under Windows The installer now informs you that the driver installation will start as shown on the left picture below. Confirm this with Next. During the following process you will see a Windows Security dialog box once or several times that asks you for confirmation to install the driver software. Confirm any such dialog with Install. ESI Audio UGM96
Drivers Under Windows - following You will now be prompted to connect the hardware on the next dialog that is shown below on the left. Plug in UGM96. Don’t click Next yet. Instead, wait a few seconds for the automatic device driver installation. You can monitor this in the task notification area where Windows Vista / 7 / 8 informs that the driver is installed via a bubble message box. ESI Audio
UGM96 Drivers Under Windows - Windows You can now finally click OK on the Information dialog. The installation is now finished. To confirm this, please check if the ESI icon is displayed in the taskbar notification area as shown below.

If yes, the driver installation has been completed successfully.

Installation under Windows XP

Disconnect UGM96 before you install the driver if it has been connected already. Then launch setup.exe from the Windows folder of the included Installation CD or from a download of a recent driver from our website after unzipping the downloaded file.
You will now see a dialog as shown on the left picture below. Click Next . You can define the target directory for the installation now. Confirm it with Next .

ESI Audio UGM96 Drivers Under Windows - fig1

The installer now informs you that the driver installation will start as shown on the left picture below. Confirm this with Next . During the following process you will see a dialog box once or several times that informs you that the driver software has not passed Windows Logo testing. Please be assured that our drivers have been tested in various different ways and are OK to be used. Confirm any such dialog with Continue Anyway. ESI Audio UGM96 Drivers
Under Windows - information

You will now be prompted to connect the hardware on the next dialog that is shown below on the left. Plug in UGM96. Don’t click Next yet. During the driver installation, Windows might again prompt you to confirm the Windows Logo testing dialog once or several times with Continue Amway before the driver installation is finalized.

ESI Audio UGM96 Drivers Under Windows - prompted You can now finally click OK on the Information dialog. The installation is now finished. To confirm this, please check if the ESI icon is displayed in the taskbar notification area as shown below.