ESi Juli XTe Under Windows Vista and 7/8 User Guide
- June 11, 2024
- ESi
Table of Contents
Knowledge Base
Installation of Juli@ XTe under Windows Vista & 7/8 (up to v1.16)
original release: 2012-06-12 | ID: KB00059EN
Introduction
This covers the installation of the Windows Vista and Windows 7/8 driver of Juli@ XTe up to version 1.16. The driver works with both 32-bit and 64-bit systems. If you have installed a previous driver already, you need to remove it first – this is described below in the uninstallation section . Then you can proceed with driver installation . A description of the installation with later drivers (starting from version 1.17) can be found here.
Installation
Make sure that you have downloaded and unzipped the driver file . Install the
Juli@ XTe hardware in your computer or if you have previously uninstalled an
older driver, reboot your system. When booting the system, Windows will detect
the hardware as a new device and a Found New Hardware dialog will appear
automatically.
Note: if the hardware is already installed in your PC but you did not
install a driver, please find the entry for an unkwon Multimedia Audio
Controller in Control Panel > System > Device Manager . Right click on that
and select the driver update option.
Make sure to click on Locate and install driver software
(recommended) . The following dialog will appear after some time:
Click
on I don’t have the disc. Show me other options. to continue. Please note that
it might take some time until the next dialog appears:
Proceed by clicking on Browse
my computer for driver software (advanced) . The following dialog will be
shown:
Click
on Browse… and then select the folder that contains the unzipped driver. Click
OK and then Next. The driver installation will now start. After some time, you
will be prompted to confirm a Windows Security message. Make sure to click
Install to continue.
The driver installation will now be completed until the
following dialog appears:
Congratulations – you can now use Juli@ XTe in your system. The control panel will appear after a few seconds in the task notification area of the taskbar.
Uninstallation
To uninstall the driver, you can use an utility that is included with the driver. Make sure you have unzipped the driver file . Open Windows Explorer and find the correct driver folder. If you are using Windows Vista/7/8 32-bit, go to the win32 folder and launch UnInstall_32 by double clicking on it. If you are using Windows Vista/7/8 64-bit, go to the x64 folder and launch Uninstall_64 by double clicking on it. When launching the uninstaller, Windows Vista might prompt a security message. Make sure to allow the uninstallation. The following dialog will appear: Click on Uninstall. After a few seconds, this dialog confirms the procedure: Note that in some cases, Windows will ask you if the uninstaller worked, confirm this with This program installed correctly . To re-install the updated driver ( as described above ), you need to reboot the system.
Copyright © 1998-2023 ESI Audiotechnik GmbH – All rights reserved.
www.esi-audio.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>