Vorago SC-202 V2 Kick Scooter User Guide

Vorago SC-202 V2 Kick Scooter

KNOW YOUR SCOOTER

CAUTION

• Read and understand all product and safety warnings.

• Do not modify the scooter.

• Before each use, check and confirm: That all protectors and pads are in place and in optimal condition; That the brake system works properly; and that the tires are in good condition and with sufficient tread remaining.

• Do not perform races, stunts or other maneuvers that can cause loss of control.

• Do not allow hands, feet, hair, body parts, clothing or similar items to come into contact with moving parts, wheels or powertrain, while the engine is running.

• Obey all local laws and regulations on scooter use and traffic.

• Don’t drive at night. Use only in adequate daylight and optimal visibility conditions.

• Do not operate in case of: Heart conditions; Pregnant women; People with head, back or neck ailments, or previous surgeries in those areas of the body; and people with any physical or mental condition.

• Always use safety equipment such as a helmet, knee and elbow pads. Always wear a helmet when riding your scooter and keep the chin strap securely fastened.
  Always wear tennis shoes.

• Wear appropriate clothing, reflective if possible.

• Avoid sharp shocks, drain grates and sudden surface changes.

• Avoid streets and surfaces with water, sand, gravel, dirt, leaves and other debris. Wet weather affects traction, braking, and visibility.

PERSONAL SECURITY

Driving the scooter without protective equipment, clothing, shoes or a helmet can cause serious injury or death. Always wear gear, clothing and a helmet when wearing your scooter.

Advice:

• Wear easily visible colors and, if possible, reflective clothing.
• Clothing suitable for the weather conditions.
• Always wear sports shoes or similar.
• The use of protective equipment, such as knee and elbow pads, is highly recommended.
• A properly fitted helmet must be worn, approved by ASTM or SNELL. at all times.

SAFETY ACCESSORIES*

USE OF THE HELMET

The use of an ASTM or SNELL certified helmet is recommended, the helmet must be worn at all times when riding your scooter.

The correct helmet should: Image 1

• Be comfortable
• Have good ventilation
• Fit correctly
• Covers the forehead

Incorrect helmet position: Image 2

• The helmet does not cover the forehead

ARMED:

1. Please connect the power cord carefully following the arrows
2. Assemble the tube to the scooter taking care not to crush the cable
3. Tighten the base screws.
4. Insert the bell into the blue handlebar grip and screw them into the handlebar (the red handlebar rotates clockwise, clock and blue on the contrary).

Before using your scooter remember:
Put it to charge (for safety the scooter does not turn on while it is find loading).
Adjust the height of the handlebar by opening the post lock (6) and pressing the height adjustment button.

PANEL:

On/Off: Hold the button down for 2 seconds.
Tail light on/off: Press the button once.
Speed change:
Press the button 2 times (Speed 1: 10 Km/h Speed 2:18km/h).
Change to miles or km: Press the button 3 times.

USE:

• To advance, gain momentum and then press the accelerator of your scooter.
• To stop you can use the electric brake located on the handle left (red color) or manually by stepping on the dashboard rear.
• To store it, just pull the lever of the folding mechanism (3) down and bend the handlebar tube until you hear a click. the bottom of it.
• To unfold it, repeat the previous point in the opposite way.

BATTERY

Use a battery or charger other than the vorago one.
Rechargeable batteries and charger can cause fire or explosion. Use only the vorago battery and charger.

Using other rechargeable batteries and charger from any other product may result in overheating, fire, or explosion. Never use the charger or batteries with another product.

Tampering with or modifying the electrical circuit system can cause shock, fire, or explosion and permanently damage the system. Exposed wiring, circuitry in charger can cause electric shock. Always keep the charger case closed.

Contact between the positive and negative terminals can cause fire or explosion. Avoid direct contact between the terminals. Holding the battery by the cables or charger can damage the battery and may cause a fire. Always take the battery by its case

Battery liquids can cause fire or electric shock. Keep all liquids away from the battery and keep the battery dry.

Stop using the scooter if the battery starts to smell, overheats, or starts to leak. Do not touch any leaking materials or breath vapors
Seek immediate medical assistance if you are exposed to any substance emitted by the battery.

This battery contains dangerous substances. Never open the battery or insert something into the battery.
Lithium ion batteries are considered hazardous materials.
Follow all federal, state, and local laws. Regarding the recycling, handling and disposal of lithium ion batteries

HOW TO FOLD YOUR SCOOTER

Press down on the folding handlebar, pull up on the long pole until you hear a click. To finish the unfolding operation, push the latch to the floor to set the latch. (image 3 and 4).
Install the handlebars and tighten the handles. (image 5)

ADJUST THROTTLE AND BRAKES

1. Loosen the screws for the throttle and electronic brake. counterclockwise with a 3mm hex wrench and loosen the hood bolts counterclockwise with a cross wrench.

2. Twist the throttle and electronic brake and adjust to an angle that can be comfortably operated while driving.

3. Tighten the throttle, electronic brake and bell bolts clockwise.

ADJUST THROTTLE AND BRAKES

Open the lock buckle and press the height limit button (the metal ball in the long hole pole), and pull the extension pole to the length (3 levels of height for option) Close the lock buckle.

STARTING THE SCOOTER

Turn on the scooter by pressing and check the battery charge. push the scooter to gain an initial speed of about 5 km / h, then press the accelerator lightly to accelerate.

Release the accelerator to gradually slow down.
Press the electric brake to stop the scooter.
Turn off the scooter when you finish using the product

RECHARGE SCOOTER

When the charger light is red it indicates that it is charging.
When the charger light is green it indicates it has finished charging.

DATA SHEET

Limited product warranty

Vorago equipment and / or accessories are covered by a limited warranty for the time indicated in the annexed validity table, counting from the date of acquisition, against any manufacturing and operation defect, provided they have been used under normal conditions of use during the warranty period and for which it was manufactured. Vorago warranty the buyer the absence of anomalies regarding the materials.

12 Months
LCD Monitor

• Except in panel (screen display) for which it will only be 12 months.

| 36 Months*
Computer equipment 3 years including Nanobay 3.

• Except computer equipment where the processor is integrated on the motherboard it will only be 12 months.

| 36 Months *

Important warranty policy: Please read and complete this warranty policy and seal it in the store when purchasing the product.

Product: Electric scooter|
---|---
Model: SC-202-V2| Dealer stamp
Brand: Vorago
Serial number:
Invoice number:
Delivery date:

Responsibilities

The total responsibility of Vorago will be to repair or replace the product, including labor and parts, at no cost to the buyer when it is returned to the point of sale, presenting this warranty policy properly completed and stamped by the establishment where it was purchased. The product or copy of the receipt or receipt or invoice, in which data of the product the date of purchase is specified, to verify the times within the warranty.
Vorago may use new parts, restored or used in good condition to repair or replace any product, at no additional cost to the consumer. In the case of equipment and / or accessories that can not be repaired, the change will be generated by a similar product or with superior characteristics. This warranty covers the transportation expenses of the product derived from its fulfillment; which will be directly attributable to the supplier of the product. In all replacement products, the original warranty period will be renewed. Vorago is governed by international standards for the manufacture of products.

How to obtain warranty support

Warranty claims are processed through the point of sale, during the first 15 days after the purchase, as long as they meet the requirements. Guarantee claims that can not be processed through the point of sale and any concerns related to the product purchased should be sent with the prepaid guide by Vorago to the address of the Vorago headquarters in Francisco Villa No. 3, Col. San Agustín, CP 45645, Tlajomulco de Zúñiga, Jalisco, Mexico.
Except in situations of force majeure or fortuitous event, the repair time in no
case will be greater than 30 calendar days from the date of receive of the equipment in Vorago.

Exclusions

This warranty is has valid in the following cases:

• a) When the product had been used in conditions other than normal.
• b) When the product has not been operated in accordance with the instructions for use.
• c) When the product has been altered or repaired by unauthorized persons by
  Vorago.

Vorago does not offier any other express warranty for this product.
To make the warranty valid, as well as the acquisition of parts, components, consumables and accessories
To validate a warranty, the following information must be sent to the email:
garantias@voragolive.com

1. – Model and color
2. – Product failure
3. – Ticket or purchase invoice (digitized)
4. – Your address with CP, telephone and full Name.

Available in the establishment where the product was purchased and / or in our central offices:

Returns
In the case of product return, it will only be the place of purchase by the end customer. Subject to the return policies established by the same seller.

Customer Service

Vorago, S.A. de C.V.
Francisco Villa No. 3
Col. San Agustín, C.P. 45645
Tlajomulco de Zúñiga,
Jalisco, México.
Tel. (33) 3044 6666
Importadora Global Rida S.A. de C.V.
Matilde Márquez No. 68
Colonia Peñón de los Baños C.P. 15520
Alcaldía Venustiano Carranza, CDMX
RFC: IGR1510164C2

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>