Thermogroup 6025 Mat Alarm Monitor Instructions
- June 11, 2024
- Thermogroup
Table of Contents
Thermogroup 6025 Mat Alarm Monitor
Product Information
6025 Mat Monitor
The 6025 Mat Monitor is a small white monitor used to monitor the integrity
of cables during tiling or screeding. It safeguards against any damage to the
heating element during the installation process and can monitor up to three
cables at a time. The monitor is designed to monitor the cables individually,
but by making a temporary “series” connection of multiple cables, it can
monitor up to three cables at a time.
Important Note: The use of the mat alarm does not replace the need for full resistance tests as outlined in the instructions for the heating system. Do not proceed with tiling, self-leveling, or screeding if the resistance reading is not within -5 to +10 of the values published on the cable labels. Once the test has been done, you will need to install the mat alarm.
Product Usage Instructions
The mat alarm is a small white monitor that is used to monitor the integrity
of the cable during tiling or screeding.
PLEASE NOTE: The use of the mat alarm does not replace the need for the
full resistance tests as outlined in the instructions for the heating system.
Do not proceed with tiling/self-levelling/screeding if the resistance reading is not withing -5Ω to + 10Ω of the values published on the cable labels. Once the test has been done you will need to install the mat alarm. The mat alarm is there to safeguard against any damage to the heating element during the tiling, screeding or self levelling process. It gets connected to the end of the cold tail. The monitor is designed to monitor the cables individually however by making a temporary ‘series’ connection of multiple cables it can monitor up to three cables at a time.
- Switch the unit on and the alarm should sound, and the red light will be lit. The alarm will sound when the cable is not connected.
- When the cables are connected the green light will be lit. If the green light goes out, please replace the batteries before continuing.
- Make sure the cables to be monitored are not connected to a power source. Wire up the cold tail to the mat alarm as per the photo opposite and details below.
- Set the switch to the ‘ON’ position and the green light will indicate that monitor is operating.
- Hangg or place the monitor where it can be seen and heard during installation.
- A red light and alarm indicates cable damage or disconnection of cables from the monitor. Check connections and the integrity of the heating cable before continuing with the installation.
- If damage to the cable is suspected please contact the technical helpline on 1300 989 464.
Wiring Instructions
- For single element:
- Terminal 1: Neutral,
- Terminal 2: Live,
- Terminal 3: Earth
- For two elements:
- Terminal 1: Neutral from mat 1,
- Terminal 2: Live from mat 2,
- Terminal 3: Earth from both mats.
Twist together the live from mat 1 and the neutral.
Important Note: Multiple mats are connected to the alarm in series for monitoring purposes only. When completing the final circuit, multiple mats must be connected to the thermostat in parallel.
Scan here to view the video on mat alarm explanation and wire up
1300 368 631
sales@thermogroup.com.au
ww.thermogroup.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>