My Easy Vac® Lightweight Upright Vacuum is loud | Support

Dirty Filters and/or clogged hoses can cause the vacuum to be loud.
Failure to properly maintain the filters could result in damage to the motor.

• Remove and empty dirt cup

• Remove pre-motor filter, turn vacuum on and feel for suction at motor duct

  • If no suction, visit an Authorized Service Center or contact us

• Disconnect filter cup from bottom of dirt cup

• Remove the Inner/Outer Circular filter from the Filter cup

• Remove the small mesh circle filter (found at motor duct below dirt cup)

• The primary separator can be removed by twisting to the left

• Filters and separator can be hand washed in warm water with mild dish soap

  • Allow to completely air dry (24 – 48 hours) before re-installing in machine

• Connect filter cup back onto dirt cup

• Lock dirt cup in place making sure there are no gaps between dirt cup and upper tank

  • If not locked properly, the seal will not be secure and cause a loss of suction or blowing dust

• Turn machine on and place hand over end of hose to check for suction

  • If no suction at end of hose, unplug machine, remove hose completely from machine, and push a broomstick through hose to clear any clogs
  • Hose needs to be replaced if cracked or damaged

• Recline handle and insert a broomstick through lower hose to clear any clogs

• Recline handle to floor, turn machine over

• Remove brush cover by taking out 5 screws

• Remove brush & belt

  • Inspect belt, brush & brush cover for damage
  • If damaged, part should be replaced

• Turn machine on while brush and belt are removed

  • If noise is gone, a new brush will be needed

If all steps have been followed and machine is still excessively loud, visit a BISSELL Authorized Service Center or Contact Us

• Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>