PULSAR Weaver LQD Rifle Mount User Manual
- June 11, 2024
- Pulsar
Table of Contents
PULSAR Weaver LQD Rifle Mount
Description
Pulsar Weaver LQD quick-release universal rifle mounts are designed to enable quick installation of Talion, Trail and Digisight/Digisight Ultra series riflescopes on a hunting shotgun. The Weaver LQD rifle mount is 97 mm in length.The Pulsar Weaver LQD quick-release universal rifle mount is designed to quickly install Talion, Trail and Digisight/Digisight Ultra series riflescopes on a hunting shotgun. The mount is 97mm in length.
Package Contents
- Rifle mount
- Fixing screws (3 screws M6X12)
- 30 Torx wrench
- Operating manual
- Warranty card
Installation Procedure
Important
Mounting slots in the riflescope base enable installation of the rifle
mount in various different positions. Choosing the rifle mount position helps
to ensure correct eye relief, depending on the type of hunting shotgun.
Installation
- Attach the fixing screws to the rifle mount.
- Pull the lock(3) to the side and turn the clasp (4) to the Open position while holding the lock.
- Mount the riflescope on the weapon rail and make sure the selected position is comfortable.
- Remove the riflescope from the weapon rail.
- Unscrew the screws one by one, apply a drop of thread locker (e.g. Loctite 638) and screw back until it stops (clamping force – 4 Nm/35.4 in-lbs). Allow the thread locker to dry as required.
- Install the rifle mount with a riflescope on the weapon rail.
- Move the clasp (4) to the Closed position .
- If there is any backlash, do the following:
- Move the clasp (4) to the Open position and push it until the adjusting nut (5) disengages from the stopper.
- Keeping the clasp (4) pressed, turn the adjusting nut (5) clockwise.
- Check the clasp (4) fixation by moving it back to the Closed position . The clasp (4) should move with little effort. There should be no backlash of the riflescope relative to the weapon rail.
- If necessary, loosen or tighten the adjusting nut (5) as described above.
- Move the clasp (4) to the Open position , the rifle mount should be easy to remove from the rail.
- The riflescope is ready for zeroing.
Mount Position Options
The Weaver LQD rifle mount can be installed in various different positions on the riflescope base to ensure correct eye relief depending on the type of hunting shotgun.
Legal Compliances and Disclaimers
The manufacturer reserves the right at any time, without mandatory notice, to make changes to the package contents, design, and characteristics that do not impair the quality of the product. For technical support please contact support@pulsar-vision.com. Answers to frequently asked questions about the devices can also be found in the FAQ section.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>