AURORA EN-ST1024IP 24V LED Strip Instruction Manual

: June 3, 2024
: Aurora

Table of Contents

EN-ST1024IP 24V LED Strip
IMPORTANT INSTALLATION INFORMATION
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

UK: 6 Little burrow
AL7 4SG, WGC
EU: 1 Rue Jean Mermoz, 95500 Gonesse

EN-ST1024IP 24V LED Strip

LED STRIP	EN-ST1024IP
LED DRIVERS	METRES PER DRIVER
AU-LED1624CV	1m
EN-LED7524	5m
EN-LEDD9024	8m

Strip Light is not suitable for dimming with Triac Mains drivers.

IMPORTANT INSTALLATION INFORMATION

Installation should be carried out by a qualified electrician in accordance with the latest edition of the National wiring regulations.
The LED Strip operates at 24V DC.
A 24V DC LED Driver is required (not included).
When connecting to an LED 24V Driver, ensure that the polarity is correct. The strip may be damaged if connected incorrectly.
Please note that the strip is IP67 but any user made connections or joints cannot be guaranteed to be IP rated.
Before commencing installation or maintenance, ensure electricity is switched off at the mains.
Ensure that ALL electrical connections are tight with no loose strands, including factory connections.
A soldering iron and heat gun are required for installation (not supplied).

24V DC LED FLEXIBLE STRIP LIGHT AND ACCESSORIES
EN-ST1024IP High Density Flexible LED strip light
EN-ST1024IPCK Connector kit accessory

To install the LED Driver please refer to their own instructions.
A maximum of 5m of can be connected in a continuous length.
For runs of over 5m connect individual lengths in parallel.
The EN-ST1024IPCK is used to connect the strip to a 24V DC Driver
At the strip connection carefully cut away the plastic sheath to reveal the +ve and – connection points.
Remove the silicone covering the LED strip to expose the copper connections.
‘Tin’ the copper track and the EN-ST1024IPCK connection wires.
Carefully solder the wires onto the LED strip.
Apply the glue to the connection and end of the strip. Next slide the sleeve in place over the connection and end of the strip.
Leave the glue to dry for 24 hours before installing. As this is a user made connection an IP rating cannot be guaranteed.
Ensure when applying strip to surface, it is smooth and clean.

Environmental Protection (W.E.E.E.) — Aurora’s WEEE Reg. No. WEE/BG0130YX (UK Only)
Waste Electrical & Electronic Equipment Regulations (WEEE) requires that any of our products showing this marking (left) must not be disposed of with other household or commercial waste. Aurora does not levy any WEEE disposal charges to its customers for affected WEEE related products. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate any such product from other waste types and recycle it responsibly at your local facilities. Check with your Local Authority, Recycling Centre or retailer for recycling advice. If, when you purchased any Aurora product, your supplier included a WEEE disposal fee, you should then contact your supplier for advice on his take back of the product for the correct disposal.

EN-ST1024IP

Document Version: EN-ST1024IPV1 20