MeTra 99-7876 Pilot 2009-up Double Din Car Stereo Instruction Manual

INSTALLATION INSTRUCTIONS FOR PART 99-7876
APPLICATIONS
HONDA
Pilot 2009-up
99-7876

99-7876 Pilot 2009-up Double Din Car Stereo

KIT FEATURES

• ISO Mount Radio Provision With Pocket

KIT COMPONENTS

• A) Radio Housing
• B) Radio Housing Brackets

Wiring & Antenna Connections (sold seperately)

• 70-1729 – Honda Harness 2008-up
• 40-HD10 – Honda Antenna Adapter 2006-up

TOOLS REQUIRED:
Small Flat Blade Screwdriver • Panel Removal Tool
• Phillips Screwdriver • Wire Cutters

*Note:
Refer also to the instructions included with the aftermarket radio.

KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry.
Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.
Metra recommends MECP certified technicians

DASH DISASSEMBLY

HONDA PILOT 2009-UP

1. Disconnect the negative battery terminal to prevent an accidental short circuit.

2. Unclip and remove the left a/c vent panel surrounding the shifter. (Figure A )

3. Unclip and remove the right a/c vent panel. (Figure A)

4. Remove the (2) Phillips screws securing the pocket below the radio then unclip and remove the pocket. (Figure B)

5. Remove (4) Phillips screws securing the radio, Unplug and remove the radio. (Figure C) Continued on page 2.
   

6. Remove the (6) screws retaining the (3) clip assemblies at the top edge of the factory radio/climate control assembly. Retain screws and clip assemblies for reuse. (Figure D)

7. Remove (4) Phillips screws securing the factory climate control. Unplug and remove factory climate control. NOTE: Retain (4) Phillips screws and climate control for reuse in Kit Assembly. (Figure E) Continue to kit preparation.
   

KIT PREPARATION

*Note: Refer also to the instructions included with the aftermarket radio.

1. Cut and remove support strut on radio housing. (Figure A)
2. Attach the (3) clips removed in step 6 of the disassembly to the 99-7876 radio housing using the factory hardware. (Figure B)
   Continue to kit assembly.

KIT ASSEMBLY

ISO MOUNT RADIO PROVISION WITH POCKET
*Note: Refer also to the instructions included with the aftermarket radio.

1. Attach the corresponding radio housing bracket to the radio housing (Figure A), then attach the climate control to the assembly using the (4) Phillips screws removed in step 7. (Figure B)
2. Position the aftermarket radio into the radio housing and secure using the hardware supplied with the radio. (Figure C)
   Continue to final assembly.

FINAL ASSEMBLY

(A) Strip wire ends back 1/2″
B) Twist ends together
C) Solder
D) Tape

1. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.)
2. Re-connect the negative battery terminal and test the unit for proper operation.
3. Reassemble radio and dash assemblies in reverse order of disassembly.

FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short circuit.

METRA / EIA WIRING CODE

12V Ignition / Acc . . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground . . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black

*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.

INSTRUCTIONS

1-800-221-0932
www.metraonline.com
REV. 7/11/11 © COPYRIGHT 2008-2010 METRA ELECTRONICS CORPORATION INST99-7876

References

• Installer Institute Announces Closure after 31 Years | installerinstitute.edu

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>