EATON ULTRALED 2-45 Autonomous Emergency Lighting Unit Instruction Manual
- June 9, 2024
- EATON
Table of Contents
ULTRALED 2-45
ULTRALED 2-8
ZNO2048600 D
Instruction Manual
ULTRALED 2-45 Autonomous Emergency Lighting Unit
C Drill in the honeycomb zones or in the flexible material.
Drilling zones to avoid
0,5 < S < 2,5 mm²
| Cabling of connectors with a screwdriver.
---|---
1,5 < S < 2,5 mm²
| Cabling of connectors by hand.
Check the packaging for the whole cabling details.
A
B Battery
C Increase Affordance
See TLU 2 manual for Increase Affordance settings.
PICTOGRAM CONFIGURATION
CEILING MOUNTING
Even
Autonomy Test Day D
Odd
AutonomyTest Day postponed by 7 days
AUTOTEST
LED DESCRIPTION
Disconnect the battery, wait for 10 seconds, and reconnect it if you decide to
change configuration (step 5).
See TLU user manual.
| Replaceable
---|---
| Not replaceable
Battery pack, Order code: FT-BAT1
If the battery duration is insufficient, replace the battery.
When the life time of light source is over, replace the luminaire.
GENERAL SAFETY INSTRUCTIONS
- The luminaire is not suitable for private use.
- It can only be installed by a qualified electrician in compliance with the regulations on safety and prevention of accidents.
- The luminaire must be used in accordance with its intended use in a proper and undamaged condition.
- Remove all foreign objects from the device before its first use.
- When working on the luminaire, first turn off the power completely, ensure that it cannot be turned back on, and check if it is free of voltage. (The above applies to mains power, backup power and possibly control and external voltage.)
- Use only original spare parts for replacement.
- *Luminaires with this label must be positioned in such a way as to avoid staring in the light for a longer time from a short distance.
- **If the luminaire is damaged or if you notice any battery abnormalities such as high temperature, discoloration, distortion, or leakage, disconnect immediately the battery and contact your customer support.
Do not attempt to repair, disassemble or modify the battery. Replacing battery
by an incorrect type could lead to explosion. Using third-party products may
cause battery leakage, overheating or fires.
Do not place or use battery near fires, heaters, direct sunlight, or other
heat sources.
Prolonged exposure to heat may cause battery leakage, explosions, or fires.
Do not place pressure on or pierce the battery with hard objects. Damaging the
battery could cause battery leakage, overheating, or fires.
Use the battery only with the luminaire intended for.
Do not immerse the battery in water or other liquids.
Do not dispose of the battery as household waste. Respect local regulations.
Powering Business Worldwide
Eaton
Cooper Sécurité SAS
PEE II – Rue Beethoven – BP10184
63204 RIOM CEDEX FRANCE
Tél. +33 (0)825 826 212 (0,15 € TTC/min)
www.cooperfrance.com
www.eaton.com
Eaton
EMEA Headquarters
Route de la Longeraie 7
1110 Morges, Switzerland
Eaton.eu
© 2020 Eaton
All Rights Reserved
DEEE : Contacter votre revendeur local
Eaton.com/recycling
ZNO2048600 D- 10/2020
Eaton is a registered trademark.
All trademarks are property of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>