MATCO TOOLS AC381450 Spotgun JR Oil Injection System Instruction Manual
- June 9, 2024
- MATCO TOOLS
Table of Contents
MATCO TOOLS AC381450 Spotgun JR Oil Injection System
SET-UP INJECTION GUN SYSTEM
-
Hold the disposable cartridge in an upright position then remove cap and seal from cartridge.
-
Attach hose (R-134a) to the top of the disposable cartridge then remove drip cap from adapter. (Fig. 1)
-
Push the release lever on the injection gun with your thumb, and pull the rod all the way back. (Fig. 2)
-
Install cartridge into gun assembly. (Fig. 3)
-
Squeeze trigger until piston seats in disposable cartridge.
Now the Injection gun system is ready to be used.
OPERATION
The Injection gun injects the oil into the NC system without the need to evacuate any refrigerant. To use, proceed with the following steps:
-
When performing an NC service refer to the service equipment’s screen after charging cycle for dosage info.
-
Connect injection gun system to the low side port of the NC system.
-
Inject oil into the NC system by squeezing the trigger (Fig. 4).
-
Disconnect injection gun system from the NC port.
-
Attach drip cap to the adapter.
-
Start the engine and turn on the NC to maximum for a few minutes. This is to circulate the new oil in the system.
-
Turn the engine “OFF”.
Note: Smaller leaks may require longer circulation time.
REPLACEMENT PARTS
- 98000010 – Jr. Metal Spotgun
- 471546 – R-134a Adapter Hose Assembly
- 471547 – R-1234yf Adapter Hose Assembly
- 399046 – PAG 46 1 oz. Cartridge
- 399046yf – PAG 46yf 1 oz. Cartridge
- 399100 PAG 100 1 oz. Cartridge
- 399150- PAG 150 1 oz. Cartridge
The World’s most Popular Injection Method!
TECHNICAL SUPPORT: 1-877-776-8486
1324 Blundell Road, Mississauga, Ontario, Canada L4Y IMS
Toll Free 1-877-776-8486
Fax: (90S) 61S-974S
www.uview.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>