MATCO TOOLS ZBCD250 Center Cut Bust-N-Out Extractor User Guide
- June 9, 2024
- MATCO TOOLS
Table of Contents
MATCO TOOLS ZBCD250 Center Cut Bust-N-Out Extractor
Bust-N-Out
Broken Bolt Removal System
System specifically designed for successful removal of sub-surface broken
bolts and studs. Each tool is made for specific bolt hole sizes to properly
prepare the broken sure face, greatly increasing the operators ability to
drill the broken bolt on center saving the existing threaded hole and the
component. Bust-N-Out carbide burrs are designed for use in high speed die
grinders. Right angle dit grinders provide the operator with proper speeds and
best control, Carefully keep too orientation straight to the surface of the
broken bolt to achieve best results,
USER GUIDE
OP 1 – Set ZBEC5
provides 5 specialty end cutting carbide burts to properly prepare (flatten)
the rough surface of the broken bolt. Use in a high speed right angle die
grinder, careful to keep burr orientation straight to the surface being
ground.. The broken surface will now be properly prepared for OP2 to locate
the broken bolts centerline.
MATCO #
- ZBEC250
- ZBEC312
- ZBEC375
- ZBEC437
- ZBEC 500
Bolt Size
- 1/4-20, 24, 28, M6
- 5/16-18, 24, 32, M8
- 3/8-16, 24, M10
- 7/16-14, 20, M12
- 1/2-13, 20, M14
OP2 – Set ZBCDS
provides 5 specialty angle grdund burs for use after OF 1, will prop- erly
locate broken bolts center point providing greater ability for the drilling
operation to drill in center.
MATCO#
- ZBCD250
- ZBCD312
- ZBCD375
- ZBCD437
- ZBCD500
Bolt Size
- 1/4-20, 24, 28, M6
- 5/16-18, 24,3 2, M8
- 3/8-16, 24, MIO
- 7/16-14, 20, M12
- 1/2-13, 20, M14
Set ZBDR4 -provides
4 solid carbide drills for drilling operation, for acceptance andard straight
flute extractors (not provided. Solid carbide drills will drill in hardened
trials. Use with drilling speeds, very carefully drill with no side pressure
to the drill.
MATCO # Dia.
- ZBDR125 1/8
- ZBDR187 3/16
- ZBDR234 15/64
- ZBDR312 5/16
for Extractor Size (Not Included)
- SEI #1
- SE2 #2
- SE3 #3
- SE4 #4
ways wear proper safety glasses and equipment when operating any cutting tool
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>