BAYU BY-FR003 Fast Wireless Phone Charger Instruction Manual
- June 4, 2024
- BAYU
Table of Contents
BAYU BY-FR003 Fast Wireless Phone Charger Instruction Manual
MODEL： BAYU-FR003
FCC ID : 2A33JBYFR003
Electrical rating: input: 100V-240V/50-60Hz, 0.3A Max; output :5V 2.1A
CAUTION:
Modifications which are not approved by the party responsible for compliance
could void user’s authority to operate the equipment
WARNING: To reduce the risk of fire, electric shock, or injury to persons:
- Use the unit for indoor only.
- Do not use extension cord(s) to connect the unit.
- Do not try to open the unit for any reason.
- The power line should be replaced by manufacturer, service orginization or qualified staff, please do not connection personally
CAUTION: Modifications which are not approved by the party responsible
for compliance
could void user’s authority to operate the equipment.
INSTALL:
- The power adapter should be used under AC 100V-240V.please check the Voltage before use it!
- Please use it in the secure environment, do not cut the cord .
- For indoor use only.
- Products commonly used on the furniture, such as the head of a bed, cabinet, sofa and so on,
- before install ,please cut off one hole to built the wireless charging ,then please connect the power adapter with the wireless charging use the USB plug.
- picture and drawing:
FCC warning:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Read More About This Manual & Download PDF: