MATCO TOOLS 1-4 ZB250 3 Piece Bust-N-Out Kit User Guide
- June 9, 2024
- MATCO TOOLS
Table of Contents
MATCO TOOLS 1-4 ZB250 3 Piece Bust-N-Out Kit
Bust-N-Out
Broken Bolt Removal System
System specifically designed for successful removal of sub-surface broken
bolts and studs. Each tool is made for specific bolt hole sizes to properly
prepare the broken sur face, greatly increasing the operators ability to drill
the broken bolt on center saving the existing threaded hole and the component.
Bust-N-Out carbide burrs are designed for use in high speed die grinders.
Right angle dit grinders provide the operator with proper speeds and best
control, Carefully keep too orientation straight to the surface of the broken
bolt to achieve best results.
USER GUIDE
OP 1 – Set ZBEC5 – provides 5 specialty end cutting carbide burrs to properly prepare (flatten) the rough surface of the broken bolt. Use in a high speed right angle die grinder, careful to keep burr orientation straight to the surface being ground.. The broken surface will now be proverly prenared for OP? to late the broken bolts centerline
MATCO #
- ZBEC250
- ZBEC312
- ZBEC375
- ZBEC437
- ZBEC 500
Bolt Size
- 1/4-20, 24, 28, MG
- 5/16-18, 24, 32, M8
- 3/8-16, 24, M10
- 7/16-14, 20, M12
- 1/2-13, 20, M14
OP2 – Set ZBCD5 – provides 5 specialty angle grdund burs for use after OP I, will prop- erly locate broken bolts center point providing greater ability for the drilling operation to drill in center.
MATCO#
- ZBCD250
- ZBCD312
- ZBCD375
- ZBCD437
- ZBCDS00
Bolt Size
- 1/4-20, 24, 28, M6
- 5/16-18, 24,3 2, M8
- 3/8-16, 24, M10
- 7/16-14, 20, M12
- 1/2-13, 20, M14
Set ZBDR4-provides
4 solid carbide drills for drilling operation, for acceptance andard straight
flute extractors (not provided). Solid carbide drills will drill in hardened
trials. Use with drilling speeds, very carefully drill with no side pressure
to the drill.
MATCO # Dia.
- ZBDR125 1/8
- ZBDR187 3/16
- ZBDR234 15/64
- ZBDR312 5/16
for Extractor Size (Not Included)
- SEI #1
- SE2 #2
- SE3 #3
- SE4 #4
ways wear proper safety glasses and equipment when operating any cutting tool