Media Hubs M Class Mark II Industrial Printer User Guide

June 3, 2024
Media Hubs

media-hubs-logo

Media Hubs M Class Mark II Industrial Printer

Media Hubs M Class Mark II Industrial Printer-featured-
image

Overview

This docum ent describes the contents and installation of the Media Hub options for the M-Class MI I
printer. Only qualified service personnel should perform this installation. After verifying the kit contents and the tools needed, follow the steps below to install the option.

Contents

The contents of the Media Hub Kit differ according to kit number:

(3-Inch Media Hub Kit) contains the following item s:

  1. 1.5-Inch Media Hub Assembly
  2. Philips Screw
  3. Hub Adapter

(40-mm Media Hub Kit) contains the following item s:

  1. 40-mm Media Hub Assembly (P/ N 15-3199-01)
  2. Philips Screw (P/ N 10-2903-04)

Installation

Caution: Only qualified service personnel should perform this installation. Always wear a wrist strap and follow standard ESD prevention measures when handling any printer circuit card assembly.

Turn OFF the Power Switch  and unplug the power cord from the AC Receptacle. Disconnect the interface cable(s). Remove the Cover Screws on the outside of the printer Media Hubs M Class Mark II Industrial
Printer-05Raise the Cover .
Loosen the Cover Screws on the Centerplate then remove the Cover . Media
Hubs M Class Mark II Industrial Printer-06Disconnect the cables from the Main Logic Card. Remove the Screws that secure the Main Logic Card and the Fill Plate to the Card Cage. Remove the Fill Plate then slide the Main Logic Card out of the printer Remove the Hanger Screw s that secure the Media Hanger to the Centerplate and then remove the Media Hanger . Media Hubs M Class Mark II Industrial
Printer-09Slide the Main Logic Card into the Card Cage and replace the Fill Plate. Secure the Main Logic Card and the
Fill Plate using the previously removed Screws. Reconnect all the cables to the Main Logic Card. Media Hubs M Class Mark II Industrial
Printer-10Remove the Ground Strap
Screw and Lock Washer , four Power Supply Screw s, and two Line Filter Screw s.
Remove the Line Filter Bracket and then remove the Power Supply. Media Hubs
M Class Mark II Industrial Printer-11Place the Media Hub
Assembly* ( Item 1) into the Hub Mount . Secure the Shaft to Hub Mount using the Screw ( Item 2) , ensuring that both are completely tightened before proceeding Media Hubs M Class Mark II Industrial
Printer-12Install the Power Supply then place the Line Filter
Bracket onto the Line Filter .
Secure the Power Supply using the Power Supply Screws and the Line Filter Screws. Media Hubs M Class Mark II Industrial
Printer-13Insert the Ground St rap
Screw into the Lock Washer and the Ground St rap Lug.
Then secure the Ground Strap Lug to the chassis using the Ground Strap Screw and Lock Washer . Check all Power Supply cable connect ions then place the
Cover onto the printer . Install and tighten the Cover
Screws on the outside of the printer . Media Hubs M Class Mark II Industrial
Printer-15Tighten the Cover Screw s on the Centerplate. Connect the inter face cable(s) . Plug the power cord into the AC Receptacle and turn ON the Power Switch.
This completes the installation process; refer to the Operator ’s Manual for media loading instructions

Media Hubs M Class Mark II Industrial Printer-17Note: The 3- Inch Media Hub Kit is configurable:
To install the Hub
Adapter ( Item 3) , align the Tabs then slide the Hub
Adapter over the 1 .5 – Inch Hub
Assembly until it seats in place; or , To remove the Hub Adapter , grasp and pull.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals