SEALEY FSW70 700mm Floor Sweeper Instruction Manual

SEALEY FSW70 700mm Floor Sweeper

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble-free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

SAFETY

• Ensure that the sweeper is only used on hard/dry surfaces.
• Ensure that the dirt collection hopper is present and properly seated before commencing sweeping.
• The sweeper is for indoor use only.
• DO NOT leave the sweeper unattended, where it could become a hazard to other people or traffic in the sweeping area. For example, in a warehouse situation.
• DO NOT allow anyone to ride on the sweeper.
• DO NOT use the sweeper for any purpose other than that for which it was designed.
• DO NOT use the sweeper to clear up hazardous materials or any material that may attack the plastic chassis of the sweeper.
• DO NOT use the sweeper on wet surfaces.

INTRODUCTION

Suitable for maintaining any hard floor and ideal for removing dirt, dust, and debris from large surface areas. Features a 4-brush system with two side brushes and two further brushes set underneath the unit to easily lift debris into the hopper. Fitted with a tubular handle and adjustable castor wheel that raises the sweeper 20mm enabling larger pieces of debris to be swept up.

SPECIFICATION

• Model no: …………………………………………………………. FSW70
• Hopper capacity:…………………………………………………….. 20L
• Operating width:………………………………………………… 700mm

ASSEMBLY

• Circular brushes: Attach each brush to its hub using the 6 screws provided (3 for each brush). Ensure each brush is correctly seated before tightening. See fig.2E&F.
• Handle brackets: Insert the right-hand bracket into the slot near the front corner of the debris collector with the thread and  spigot facing outwards as shown in fig.2G. Secure the bracket using the 25mm self-tapping screw provided, as shown in fig.2H. Mount and secure the left-hand bracket in the same way.
• Lower Handle: Take the lower handle tube and place theslots in the flattened ends over the threaded spigots on the handle brackets. Ensure that the open slots at each end of the lower handle are engaged with the plain spigot on the mounting brackets. Retain the handle in place by screwing a black plastic knob onto each threaded spigot. See fig.1B.
• Upper Handle: The upper handle has three alternative mounting holes in the flattened portions of the handle. Align the chosen mounting holes with the holes in the upper part of the lower handle and insert the supplied coach bolts through both frames and retain with the black plastic knobs supplied as shown in fig.1C&D.
• Handle stowage: The handle can be folded down for storage purposes. Loosen the lower mounting knobs and pull the handle upwards to disengage the slotted ends from the plain spigots on the mounting brackets. See fig.1B&A. Hinge the handle forwards and allow it to rest on the body of the sweeper.

ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling center and disposed of in a manner that is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications, and component parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from the purchase date, proof of which is required for any claim.

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>