Steba KH2 Ceramic Fan Heater Instruction Manual

June 9, 2024
Steba

Steba KH2 Ceramic Fan Heater

Product Information

  • Model: Keramikheizer KH2
  • Power supply: 230 V~; 50 Hz; 1.800 W
  • Manufacturer: Steba
  • Product website: www.steba.com

Product Usage Instructions

  1. Ensure that the power supply matches the specifications stated on the product.
  2. Do not operate the appliance near or with water, and do not allow it to be operated by persons with reduced physical, sensory, or mental capabilities.
  3. Before performing any maintenance or cleaning, make sure that the appliance is switched off and unplugged from the power source.
  4. Place the appliance on a stable and level surface, at least 1 meter away from any air vents and 50 cm away from any walls or curtains.
  5. Do not block the oscillation function of the appliance, and clean the filter sponge regularly by pulling it out from the back of the appliance, washing it in lukewarm water, drying it thoroughly, and reinserting it.
  6. Dispose of the appliance correctly according to local regulations, and contact the manufacturer’s customer service for any issues or inquiries.
  7. Refer to the model identification section for specific features and functions of the appliance.
  8. Read and follow all safety information provided in the instruction manual, and supervise children when using the appliance or performing any maintenance or cleaning.

Generally

This appliance is for private and indoor use only and must not be used commercially. Please read the instruction manual carefully and keep it at a safe place. When the appliance is given to another person the instruction manual should be passed to that per-son, too. Only use the appliance as described in the instruction manual and pay attention to the safety information. No liability for damages or accidents will be accepted, which are caused by not paying attention to the instruction manual.

Safety information

  • The appliance can be used by children aged 8 and above and persons with limited physical, sensory or mental capabilities or lack of experience/knowledge, provided that are supervised or have been provided with instruction in the safe use of the appliance and have understood the resulting dangers. Children must not use the packaging as a plaything. Cleaning and user maintenance must not be carried out by children un-less they are 8 years or older and are supervised.
  • Children of less than 3 years should be kept away unless continuously supervised.
  • Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
  • The appliance must not be operated using a timer or a separate remote system!

For your own safety

  • This fan heater is an extra-heating in the house. It must be used according to this concept.

  • Make sure that your supply rating corresponds to what specified on the rating plate i.e. 230 V AC, 50 Hz.

  • Don’t leave your home while the appliance is in function: ensure in this case that the switch is in OFF (0) position.

  • During function, place the heater in a safe position :

  • far (1 mt. ) from inflammable objects or furnitures; if wall mounted, not fixed to wooden or synthetic plastic surfaces;

  • leaving the air outlet space free : 1 mt. of free space in front of the heater and 50 cm. of free space behind it;

  • not located immediately below a socket-outlet.

  • Do not leave animals or children touch or play with the appliance.

  • Pay attention!
    The air outlet grille gets hot during operation (more than 80°C i.e. 17 5°F). Parts of this product may be very hot and cause burns. Special attention is needed when children or vulnerable persons are present.

  • Take care, that children are not playing with packaging material (e.g. Plastic Bags)
    WARNING: In order to avoid overheating, do not cover the heater. Do not hang anything on the heater and do not cover it while it’s working. This is clearly written on the cover of the product or shown by the symbol

  • Do not use the heater in rooms with explosive gas or while using inflammable solvents or varnish or glues.

  • If the cordset is damaged and you have to change it, do not do the job yourselves! Take the product to an after sales authorized repair Centre or to a person with similar skill and knowledge, in order to avoid any risk of danger.

  • Do not use this heater close to showers, baths, swimming pools.

  • The appliance must be positioned so that the plug is always accessible and not to be hot blown on.

Safe positioning

  • The appliance must be used only on a flat, stable surface.
  • The fan heater only operates when the safety switch on the bottom of the unit is pressed.
  • The appliance must be not accessible for persons who are ta-king a bath or in the shower.
  • Do not place the cable under a carpet.
  • Mind that during function the cordset must be always completely pulled out.

Use of the heater

  • 1800 W (Oszillation)
  • 900 W (Oszillation)
  • OFF
  • 900 W
  • 1800 W

Oscillation

  • Due to the oscillation (turning) a more equal temperature in the surrounding is achieved.
  • Never block the oscillation movement.

Use of the thermostat

  • In a room where the temperature is too high (more than 30°C), it is normal that the thermostat will not switch on the heater.
  • In a room where the temperature is too low (around 5°C or even less) it is also normal that the thermostat will keep the appliance working until the temperature gets higher.
  • To select the right thermostat position we suggest you to
    • turn the thermostat in maximum position (clockwise);
    • leave the appliance working until the comfortable temperature is reached;
    • turn the knob anti clockwise until you hear a „click“ and the red indication light turns off;
    • turn clockwise again the knob (just a little): in this position the thermostat will maintain the comfortable temperature you have selected. The red indication light shines if the heater turns on again.
  • If the appliance is used for the first time there can be a little smoke due to some production oil residues.

To clean the filter proceed as following (picture)

  • Pull out the power plug;
  • Loosen the filter-screw at the back of the product and pull it backwards;
  • Remove the sponge filter from its holder;
  • Clean the filter by water with wash power under the temperature of 30°C.

Safety in case of abnormal operation

  • In case of overheating the safety cut out protecting the heating element will auto-matically switch off the appliance.
  • In this case the appliance stops working and the pilot light will remain switched on even if the appliance is not working.
  • If this happens:
  • switch off the fan heater;
  • remove the causes of abnormal operation or overheating (i.e. obstacles in front of air inlet or air outlet grille);
  • leave the heater cool down for 15/20 minutes;
  • switch on again the fan heater.

Maintenance

  • This fan heater does not require any particular maintenance.
  • We only recommend to clean at least twice a year the air inlet and air outlet grille with a vacuum cleaner to remove dust from motor and heating element.
  • In case you need to repair it, please contact an authorized repairing center.
  • If the cordset is to be changed, please mind that a 2x1mm2 H05VVF cordset is to be used.

Correct Disposal of this product

This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

Packaging disposal: Do not throw away the package materials. Please put it in the recycling bin.
Gift box: Paper, should be put to the old paper collection point. Plastic packaging material and foils should be collected in the special collection containers.

Service and Repair

If the appliance must be repaired, please get in touch with your trader or with the manufacturer:
STEBA Elektrogeräte GmbH & Co KG
Pointstr. 2, 96129 Strullendorf / Germany
Distribution-Tel.: 09543 / 449-17 / -18, Service-Tel.: 09543 / 449-44, Fax: 09543 / 449-19
e-Mail: [email protected] Internet: http://www.steba.com

Information requirements for electric local space heaters

Model identifier: KH 2

Item| Symbol| Value| Unit| Item| Symbol| Value| Unit
Heat output| Auxiliary electricity consumption
Nominal heat output| P nom| 1,8| kW| At nominal heat output| el max| 0| kW
Minimum heat output (indicative)| P min| 0,9| kW| At minimum heat output| el min| 0| kW
Maximum continuous heat output| P max,c| 1,8| kW| In standby mode| el SB| 0| kW
Item| Unit
Type of heat input, for electric storage local space heaters only (select one)|
manual heat charge control, with integrated thermostat| NO
manual heat charge control with room and/or outdoor temperature feedback| NO
electronic heat charge control with room and/or outdoor temperature feedback| NO
fan assisted heat output| NO
Type of heat output/room temperature control (select one)|
single stage heat output and no room temperature control| NO
Two or more manual stages, no room temperature control| NO
with mechanic thermostat room temperature control| YES
with electronic room temperature control| NO
electronic room temperature control plus day timer| NO
electronic room temperature control plus week timer| NO
Other control options (multiple selections possible)|
room temperature control, with presence detection| NO
room temperature control, with open window detection| NO
with distance control option| NO
with adaptive start control| NO
with working time limitation| NO
with black bulb sensor| NO
Contact details| Steba Elektrogeräte GmbH & Co.KG Pointstr. 2
96129 Strullendorf

Steba Elektrogeräte GmbH & Co. KG
Pointstraße 2, D-96129 Strullendorf
[email protected]
www.steba.com
Zentrale:
Tel.: 09543-449- 0
Fax: 09543-449-19
Vertrieb:
Tel.: 09543-449-17
Tel.: 09543-449-18

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Steba User Manuals

Related Manuals