Steba DF 95 Mini Fryer with Fondue Set Instruction Manual
- June 3, 2024
- Steba
Table of Contents
Steba DF 95 Mini Fryer with Fondue Set
Generally
This appliance is for private and indoor use only and must not be used commercially. Please read the instruction manual carefully and keep it at a safe place. When the appliance is given to ano-ther person the instruction manual should be passed to that per-son, too. Only use the appliance as described in the instruction manual and pay attention to the safety information. No liability for damages or accidents will be accepted, which are caused by not paying attention to the instruction manual. Remove all pa- ckaging and sticker (except the rating label). Wash up all parts carefully (see cleaning).
Safety information
- Hot surface! There is danger of burning when touch-ing the surface during operation. Set the back of the device with a distance of 10cm to the kitchen wall.
- Connect and operate the appliance in accordance with the specifications shown on the rating label.
- Do not use if the plug cord is damaged. Verify before every use.
- Do not plug with wet hands.
- Connect the power plug to a properly installed and easily accessible socket only.
- To unplug the power plug, always pull the plug – not the cable.
- Plug off the appliance after each use or in case of failure.
- Do not pull at the cord. Don’t pull it over edges and don’t bend it too much.
- Keep the cord away from hot parts.
- The appliance can be used by children aged 8 and above and persons with limited physical, sensory or mental capabilities or lack of experience/knowledge, provided that are supervised or have been provided with instruction in the safe use of the appliance and have understood the resulting dangers. Children must not use the packaging as a toy. Cleaning and user maintenance must not be carried out by children unless they are 8 years or older and are supervised.
- Children under the age of 8 must be kept away from the appliance and the connecting cable.
- Children should be supervised to ensure that they do not play with the appliance or packaging material (e.g. Plastic Bags).
- The appliance must not be operated using a timer or a separate remote system!
- Never leave the appliance unattended when in use.
- Do not leave the appliance outdoors or in a damp area.
- Never place anything on top of the device and do not cover the ventilation slots.
- Never immerse the unit in water.
- Leave a space of about 10cm around the device.
- Never use the device after a malfunction, e.g. if it felt down or has been damaged in any other manner.
- The manufacturer is not liable for damage which is occurring due to the usage of the appliance in a different way as described or a mistake in the handling has been made.
- To prevent injury, repairs such as replacing a damaged cord, should only be carried out by a customer service. Only original spare parts have to be used.
- The device gets hot, only transport after it cooled down.
- Only use the device as described in this manual.
- You must not put any materials such as paper, cardboard, pla-stic etc. into the appliance.
- This appliance is intended to be used in household and similar applications such as:
- staff kitchen areas in shops, offices and others working environments
- by clients in hotels, motels and other residential type environments
- bed and breakfast type environments.
- Before initial use: clean all parts carefully and leave to dry.
- Attention! Device gets hot. Danger of burns! Do not place the appliance on a sensitive surface (e.g. painted furniture) and keep a distance of at least 70cm to burnable materials.
- During operation steam emerge. Keep hands and face away. Take appropriate distance to wall cupboards to avoid damage of the veneer.
- If an extension cable is used, it has to have a cross-section of 1,5mm². A cable drum must always be unwound.
- If a GS-tested 16 A multi-pin extension is used, it may not be charged with more than 3680 watts due to fire hazard.
- Make sure that children do not tease the cable or that a trip hazard occurs.
- The device must always be disconnected from the power supply if it is not supervised and before assembling, disassembling or cleaning.
- Hot steam may leave the louvers. Never place any wet food into the device, thaw frozen food slightly.
- Hygiene: Please always clean the device to avoid bacteria and mould formation.
Danger of splashes!
- To avoid splashes or foaming of the fat only use food which is not too wet (dry the food with cloth, remove ice from the food etc.). Insert the food slowly into the fryer.
- Condensation can form on the lid during frying.
- Be sure to wipe off the water before using the deep fryer again or closing the lid again.
- Do not put water in the hot fat. Risk of burns!
Cleaning
- Attention! Pull the plug before cleaning and allow the device to cool down.
- Never immerse the unit into water.
- The device should be cleaned thoroughly each time the fat is changed.
- Pull the opened lid straight up from the device.
- There is a permanent filter in the lid; open the cover to remove it. Clean the filter with warm soapy water, let it dry and then put it back in place.
- Remove the basket.
- Carefully pour the cold fat into a saucepan. (See cleaning frying fat)
- Lid, basket and device can be cleaned with warm water with the addition of commercially available washing-up liquid.
- Then dry the parts well and make sure that there is no water in the lid.
- Do not use any harsh or abrasive cleaning agents.
- Reassemble the device after cleaning.
Workplace
Important:
Never place this device on or next to hot surfaces (e.g. hot stoves). Only use
it on a even, stable and a heat resisting surface. It is important that no
inflammable items are near to the device. Do not place the device on the edge
of the table so that it cannot be touched by children or fall down when
touched.
Fat and oil:
Important: Deep frying fat must be heatable to a high temperature. The
smoking point must be at about 220°C.
The food must be put in at a temperature of between 170°C and 190°C. Deep
frying oil is suitable. Never switch deep fat fryer on when empty. Pour oil
into the unheated container. Cold-pressed and non-hardened oil or fat such as
olive oil, wheat oil, linseed oil, pork fat and butter are unsuitable.
Important: Never mix oil and fat because the deep fat fryer may foam
over. It is also dangerous to mix different kinds of oil or fat!
The filling level indicator is inside the container. The MAX filling level may
not be exceeded, and the minimum filling level must not be undershot.
Risk of scalding!
Be extremely careful with hot fat, and keep children away.
Assembly of the handle
on the frying basket DF 300
Deep fat frying
Place the prepared food into the frying basket and distribute over the entire
surface. Do not place too much food in the fryer. Then slowly immerse the food
in the fat. Close the filter lid again. The filter lid provides protection
from fat splashes and re-duces the smell of fat.
Observe the procedure through the lid window. If the fat foams up excessively,
open lid and raise and lower the basket several times by raising and lowering
the handle until the foaming subsides.
Caution! Used or contaminated fat or oil can self-ignite if overheated, which is why the oil should be replaced in good time. In the event of a fire, disconnect the plug form the power supply and extinguish burning fat by covering with the lid. Never extinguish using water!
- Lid window
- Detachable lid
- Permanent filter
- Oil tank
- Handle
- Housing
- Temperature control
- Temperature control light
- Button to open the lid
- Frying basket
- Fondue ring
- Fondue forks
Operation
- Never operate the device without oil and check the MIN / MAX filling quantity.
- The oil level, including food, must never exceed the MAX mark.
- Connect the cable.
- Set the desired temperature between 80 and 190 ° C with the help of the temperature regulator.
- The control lamp shows that the device is heating up.
- When the temperature is reached, the light switches off.
- The basket with the food can now be placed in the deep fryer.
- Set the temperature control back to OFF after deep-frying.
Important note on the use of hard fat (e.g. coconut fat):
- Cut the fat into small pieces and put it in the container. Do not put in the basket!Set the thermostat to the melting setting to carefully melt the fat.
- If the fat has hardened after use in the deep fryer, it must also be melted again on the melting setting.
- As soon as the fat has melted, the desired frying temperature can be set.
Monitoring the deep fat frying procedure
The frying procedure can be monitored through the inspection window in the
lid. Lifting the basket a little may give you a better view.
When the food is cooked
- Open lid.
- Caution – lid may be hot!
- Lift frying basket and hook onto edge of pan.
- Once the fat has drained, remove frying basket and empty. Do not season the food over the fryer – this will protect the fat and the fryer.
- If no more frying is being carried out, turn down the temperature and disconnect plug from power supply.
Deep fat frying table
Important Tips:
According the latest knowledge of researchers, following max. temperatures
should be obeyed and all foods should be fried max to a gold colour:
- 170°C for all potatoes, breaded food and all other starch containing products
- 190°C for meat and poultry with no breading
In opposite to the tips on the packaging of frozen food we advise to defrost the food short before frying to avoid any ice inside the fryer.
After deep fat frying:
Clean the fat:
Residue from the breadcrumb coating or the food should be removed from the
fry-ing fat or oil at regular intervals.
-
First allow the fat to cool after frying, then carefully pour the fat into a metal pan with handles.
-
Coating residue and water in the oil must be removed.
-
Clean the frying basket and the pan (see paragraph “Cleaning and care”).
-
Hook frying basket into the fryer (draining position, place kitchen paper in basket as a filter).
-
Slowly pour the fat back into the fryer through the filter paper.
-
Only use the paper fat filter once.
Replace the frying fat if: -
It has turned brown
-
It has an unpleasant smell
-
Starts to smoke sooner than expected
Pour the liquid oil that has not yet fully cooled down into a container with a closure. Used fat and oil should not be poured onto compost or down the drain. If large quantities are being produced, ask your local authority for the location of a collection point.
Practical tips for frying
Dry the food carefully before putting it into the fat, tap superfluous flour,
press the breading firmly. Food containing much protein such as fish, poultry,
meat and seafood can be fried in the raw if they are well dried. Food
containing little protein such as vegetables and fruit should be coated with
breadcrumbs or with batter, hereby the pores close quickly. The crust is also
ideal for frying meat, poultry, fish and seafood.
Fondue
When the device is used as a Fondue, remove the lid by pulling the lid
upwards. Put the Fondue ring on the appliance for the Fondue forks.
Leave the frying basket inside the appliance, as the bottom will be not
damaged or food which has fallen off can be removed easier from the fat.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
Packaging disposal: Do not throw away the package materials. Please put
it in the recycling bin.
Gift box: Paper, should be put to the old paper collection point. Plastic
packaging material and foils should be collected in the spe-cial collection
containers.
Service and Repair:
If the appliance must be repaired, please get in touch with your trader or
with the manufacturer:
STEBA Elektrogeräte GmbH & Co KG
Pointstr. 2, 96129 Strullendorf / Germany
Distribution-Tel.: 09543 / 449-17 / -18,
Service-Tel.: 09543 / 449-44, Fax: 09543 / 449-19
e-Mail: elektro@steba.com Internet:
http://www.steba.com