YCKJNB B09SV3TVPK 360 Photo Booth 39.4 Machine User Guide

YCKJNB B09SV3TVPK 360 Photo Booth 39.4 Machine User Guide

Attention

1. Before using, please check whether the power cord, base LED Strip cord and other items are stuck on the rotating table or not, to prevent the cables from being damaged.
2. For users’ safety, don’t jump hard on the Stage.
3. Don’t make the edge of the Stage bear too much weight, better distribute the weight evenly on the stage.
4. The Stage should be adjusted paralleled to the ground by rotating the foot cup before using.
5. Do not stop the rotating rod deliberately when it was running.
6. Do not put heavy objects on the Angle Adjuster and Selfie Telescopic Rod.
7. Children should not use it alone but must be accompanied by an adult.
8. Pls, take off the foot cups when putting the photo booth into the flight case for transportation.

Component Introduction

The attachments received are subject to

installation Guide

Step1: Take the Stage out of the package, install all the 8 Foot Cups and adjust the Stage parallel to the ground. Then connect the AC-DC adapter to the Motor Controller.

Step 2: Install the Angle Adjuster, and lock it with Fixed Screw.

Step 3: Install the Selfie Telescopic Rod.

Step 4: Stick the LED Strip to the base and connect it to 5V Adapter (for LED Strip).

Step 5: Install Ring Light.

Step 6: Install Fixed Bracket and Phone Holders.

Step 7: Power bank, lithium battery connection, and usage(Power Bank and lithium battery are not our standard accessories). The Ring Light should con­nect with USB port of the power bank. The motor controller should connect with the lithium battery s DC 24V power port. And the LED strip should connect with the lithium battery s DC 5V USB port.

1. Lithium Battery.
2. Power switch of the Battery.
3. DC 12V output port.
4. DC 24V output port. Supply the photo booth power with this port connec­tion.Also this is the Lithium Battery charging port.
5. 5V USB port, connected with the LED Strip.

1. Ring Light USB connectio with Power Bank.
2. Brightness Increase Button.
3. Brightness Decrease button
4. Temperature Switch.
5. Power Button

Operation Instructions

Install suitable batteries for all remote controls(CR-2032). Power up the AC- DC adapter.
Plug the two USB(Ring Light& LED Strip) into the power bank and 5V adapter.

Remote Control Instructions

Lightband Controller Instructions

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>