eta 7341 Hair and Beard Trimmer Instruction Manual

: June 4, 2024
: ETA

Table of Contents

eta 7341 Hair and Beard Trimmer
SAFETY WARNING
DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES
INSTRUCTIONS FOR USE
MAINTENANCE
ENVIRONMENTAL PROTECTION
TECHNICAL DATA
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

eta 7341 Hair and Beard Trimmer

INSTRUCTIONS FOR USE
Dear customer, thank you for purchasing our product. Please read the operating instructions carefully before putting the appliance into operation and keep these instructions including the warranty, the receipt and, if possible, the box with the internal packing

SAFETY WARNING

Before the first use, read the instructions for use carefully, look at the picture and keep the instructions for use.
Check whether the data on the type label correspond with the voltage in your socket.
This appliance may only be used by children aged 8 years or older, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children under 8 years of age must keep away from the appliance and its USB power cable.
To power the appliance, only apply safe small voltage of =5.0 V.
The appliance has no charging source of its own, it is only designed for charging via USB (an adapter with USB output with output voltage of =5.0 V, and output current of at least 1000 mA). Before making any connection, please pay attention to instructions of the manufacturer of the respective power source.
Before replacing accessories or accessible parts that move during the use, before assembling and disassembling, before cleaning or maintenance,
if you leave the appliance unattended or after completing the work, always perform the following with the appliance switch off and disconnect from the power supply.
Never use the appliance if the USB power cable is damaged, if it does not work properly, if it fell to the ground and got damaged. In this case take the appliance to a special service to check its safety and proper function.
The appliance and the connected adapter must not be used at places where it could fall into bath tub, wash basin or swimming pool. If the appliance fell into water anyway, do not take it out! First of all, unplug the adapter from the socket and only then take the appliance out. Then bring the appliance to a specialised service centre to check its safety and proper functionality.
If the appliance is used in a bathroom, it must be disconnected from the mains after use by unplugging the power cord from the wall socket, because the appliance poses a risk if near to water, even when switched off.
The appliance is intended for use in households only and for similar use! It is not designed for use in hair salons or for other commercial use!
Never immerse the appliance or the adaptor in water or other liquids (not even partly) and never wash in running water!
Be careful in using the appliance without a set adapter, the blades are sharp.
Do not use the appliance while having a bath, having a shower or taking a sauna and for trimming wet or artificial hair.
Never leave the product unattended when in operation!
The appliance is intended to be charged from a detachable nower supply unit.
The appliance is not intended for styling animal hairs.
Never charge the appliance in direct sunlight or close to heat sources and if the temperature is below 10 °C or above 40 °C. If the appliance is fully loaded, unplug the charging device.
In case the cutting lath gets blocked, the appliance must be turned off immediately and the cause removed.
The appliance gets hot when charging which is absolutely normal.
Charge the battery in temperature close to room temperature.
Do not dispose the battery into fire. There is a risk of explosion!
Do not charge a battery which is leaking electrolyte.
Do not expose the battery to temperatures higher than 50 °C to prevent damaging the battery.
Do not put the trimmer on hot heat sources (e. g. oven, stove, radiator, etc.)
Also, do not put the appliance in the on position on soft surfaces (e. g. bed, towels, sheets, carpet); the surfaces or the appliance could get damaged.
Never place the USB power cable onto hot surfaces and do not leave it hanging over the edge of a table or worktop. If someone, e.g. a child, brushes against the cable or tugs at it, the appliance might overturn or fall down and it might result in a serious injury!
The USB power cable must not be damaged by sharp or hot objects or open flame, it must not be submerged in water or bent over sharp edges.
Use only designated accessories enclosed. Using other types of accessories can present a risk for the operator.
Only use this appliance for the purpose it was designed for, as specified in this manual. Never use the appliance for any other purpose.
During normal operation, the accumulator batteries are not taken out. Take out the batteries only if the appliance is to be disposed (see par. V. ENVIRONMENTAL PROTECTION).
The producer is not responsible for any loss caused by improper handling of the appliance and its accessories (e. g. injury, appliance damage, fire, etc.) and its guarantee for the appliance does not apply in the case of non-compliance with the safety instructions above.

DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES

A trimmer
- A1 – on/off button + change speed
- A2 – cutting speed (TURBO)
- A3 – leftover battery indicator
- A4 – blade cut length switch (0,8 – 2,0 mm)
- A5 – cutting head
- A6 – blade
B – attachments
- B1 – comb attachment (3 mm)
- B2 – comb attachment (6 mm)
- B3 – comb attachment (9 mm)
- B4 – comb attachment (12 mm
C – charging USB cable
D – charging stand
E – brush
F – blade lubrication oil G – travel case

INSTRUCTIONS FOR USE

Before you can use the appliance, its batteries must be charged. The operation time for one charge depends on the attachment used and workload. Attachment is around 120 minutes.

To Charge/Recharge

Fully charge Clipper before using for the first time or after non- use for a long period of time.
Charging or recharging at temperatures below 10°C or higher than 40°C adversely affects lifespan of the battery.
Continuously recharging Clipper will reduce lifespan of battery.
Do not use USB ports on other devices (e.g. computers, laptops, tablets, mobile phones, etc.) to power the appliance. Such devices may not be dimensioned for the current consumption of the appliance and it could damage them.

Be certain Clipper is OFF.
Select the charging method (directly via cable or using the charging stand) see Fig. 2.
Charging is signaled by the gradual flashing of the numbers representing the percentage of charge of the indicator A3. When fully charged, the value 100 remains lit.
It will take approximately 2,5 hours to fully charge the Clipper. Do not exceed the set time of charging!
After charging, unplug the adaptor from the mains first and only then unplug the connector from the appliance.

Optimize the working life of the battery

Do not charge for more than 2 hours.
Do not keep cord permanently plugged in.

Use
The trimmer can be used without the adapter (for cutting contours) or with the selected adapter B1–B4 according to the required cut length.

Controls

Turn on the trimmer – if it is off, shortly press the A1 button.
Change the trimming speed – shortly press the A1 button when in operation.
Turn off the trimmer – shortly press the A1 button.

Hair clipping

We recommed oiling the blades with the oil F attached before first use.
Before you start clipping, make sure that the head of the person whose hair you are cutting is at the same level as your chest so that all parts of his/ her head are clearly visible and within easy reach.
Only use the clipper on dry hair.
Do not use on freshly washed hair.
Before you begin, comb the hair in the direction of growth.
To achieve optimal clipping results, always move the clipper slowly through the hair against the direction of hair growth.
In case an blade A6 gets blocked, the appliance must be turned off immediately and the cause of the block removed.
Note
You may also use the blade cut length switch A4 for finer cut setting.

Clipping with hair comb attachment

Put on the desired comb attachment (B1–B4), see pic 4A, B. Then you can turn on the appliance.
If you are trimming for the first time, begin by trimming with an attachment of max. length to prevent too short of a cut. When you have familiarized yourself with the settings, use attachments B with lower length.
Make sure that the flat part of the comb is always in full contact with the scalp to obtain an even result.
Move the clipper slowly over the crown from different directions to achieve an even result.
Always move the clipper against the direction of hair growth.
Make overlapping passes over the head to ensure that all hair that should be cut has been cut.
Turn the Clipper off and remove the hair comb often to blow and/or shake out hair that has accumulated.

Contouring without the hair clipping comb attachment

Remove the hair comb (if it is attached). Be careful when you are clipping without comb attachment as when the clipper is turned on it will trim every hair it touches.
Tilt the clipper in such a way that only one edge of the trimming attachment touches the hair ends when you shape the contours around the ears.
To contour the nape of the neck or hairline, turn the clipper and hold it with the trimming attachment pointing downwards.
To contour the sideburns, turn the clipper and hold it with the trimming attachment pointing downwards.

Trimming facial hair

Mark a facial hair line with the trimmer and cut off the hairs exceeding this line from the outer perimeter
If you want to achieve an even trim of facial hair, use one of the attachments B or trim carefully the ends by small pieces over the brush in such a way that the brush moves through the hair upwards. Repeat the process in the whole facial hair area.
After trimming shave the parts around the beard in a usual way.

Trimming a mustache
Trim carefully over a brush to achieve an even cut of the mustache. If you prefer using your finger as a guide, proceed accordingly.

MAINTENANCE

Do not use rough and aggressive detergents! Wipe the trimmer surface with a wet soft cloth.
Cleaning blades (See fig. 3 A for removal; see fig. 3 B, C, D for reassembly) Clean the blades with the brush attached. For thorough cleaning, the entire trimming head A5 can be removed. With your thumb, push the A6 blades and remove the trimming head in the direction of the arrow. When you want to re-attach it, put the plastic projection in the rear part of the trimming head into the opening in the trimmer and re-attach the trimming head (snap it in).
In order to keep the trimmer in a perfect condition, you have to lubricate the list with blades using one or two drops of oil for sewing machines. Do not use hair oil, petroleum jelly or oil mixed with petrol or any other solvent because after evaporation the solid parts of the lubricant could slow down operation of the blades. Insert the trimming head to the trimmer properly, turn on the trimmer and then turn it off and wipe out the excessive oil from the blades.
Storage
Put the trimmer with the accessories back to the original package at a dry and dust free place, out of reach of children and incapacitated people.

ENVIRONMENTAL PROTECTION

If the dimensions allow, there are marks of materials used for production of packing, components and accessories as well as their recycling on all parts. The symbols specified on the product or in the accompanying documentation mean that the used electrical or electronic products must not be disposed of together with municipal waste. For proper disposal, hand them over at the special collection places where they will be received free of charge. Suitable disposal of the product can help to maintain valuable natural resources and to prevent possible negative impacts on the environment and human health, which could be the possible consequences of improper waste disposal. Ask for more details at the local authorities or at a collection site. Fines can be afflicted for improper disposal of this type of waste in agreement with the national regulations. The appliance is equipped with rechargeable Li-ion batteries with long life. Dispose of the batteries in a suitable and safe way through the special collection networks. Never dispose of the batteries by burning!

TECHNICAL DATA

Voltage (V) specified on the type label
Trimmer weight (kg) 0.2
Appliance Protection Class III
Dimensions (H x L x W) 40 x 167 x 45 (without attachments)
Noise level: Acoustic noise level of 65 db(A) re 1pW.
The manufacturer reserves the right to change the technical specifications and accessories for the respective models.
More extensive maintenance or maintenance requiring intervention in the inner parts of the appliance must be carried out by professional service! Failure to comply with the instructions of the manufacturer will lead to expiration of the right to guarantee repair!
Guarantee of 24 months does not apply to decrease in the accumulator’s effective capacity caused by its use or age. Effective capacity gradually decreases depending on the method of use of the accumulator.
Oil: Warning, Avoid contact with eyes, Do not drink, Keep away from children or mental capabilities.

HOUSEHOLD USE ONLY. DO NOT IMMERSE IN WATER OR OTHER LIQUIDS.
TO AVOID DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG IS NOT A TOY.

NOTICE

Do not use the appliance close to bath tubs, showers, bash basins or other water containers.
– Please read the instructions manual
emovable power supply unit